开云体育

Hello, (I have not read the manual, my apologies in advance.

?

Today during an operations session, there were many shorts, a good amount caused by operator error, but other from normal things. All the shorts were quickly cleared, but I then had to manually reset the YD7001. My layout is not that big, so originally I was not planning to install circuit breakers. But, I would also like a solution that will try to reset track power after a few seconds, only completely shutting down if the short is not cleared quickly.

?

Is it possible to set the YD7001 to retry track power after like 5 seconds, try 3 times, then require a manual restart after 15 seconds? Or some other similar scenerio?

Or do I need to get circuit breakers installed if I want this feature?

?

Thanks

--

Heath @ Human[c]ity

I have looked in the manual since finding this, and I have not found anything regarding short protection.

--

Heath @ Human[c]ity

Glad to see you managed to RTFM.

?

Shorts. These are not "normal". My system runs very well without them...... If you are getting shorts for any reason, then you need to understand why and then take action to prevent them.

?

Reset. It's manual. This will encourage action to remove causes of shorts. To continually reset onto a short condition will stress things. Then they die.

?

Pete S