开云体育

HI,
I have recently upgraded my DR5000 to a YD7001.? Its working great, I was getting intermittent disconnects with iTrain but these have now gone.?

My iTrain/YD7001 interface uses a LAN connection, no problems., however I cannot? I cannot establish a connection over my network from the YD7001 Configurator App to the YD7001. I get an error message saying that it cannot establish a connection, when I look in the log there is a entry saying that it could not establish a connection within 1 second.

I change the control back to USB and all is well.

Any suggestions?

Thanks in advance.

Alan

Please ignore, I recognised my error and am now accessing via my browser.

Good morning.
I return to this topic because there is something I must be doing wrong. I would like to connect the YD7001-E directly via LAN but it does not recognize it. Yes, it connects via WIFI and also via USB, but I don't know why it doesn't connect via LAN only.
As I have read in the manual, it is better to do it from LAN. The cable is CAT6 and is 2 meters.
What am I doing wrong?. Is it something on my PC?
Thank you so much.
Greetings,
Mario

Good morning.
This is where I have to modify the IP of my PC and put what the Yamorc YD7001-E indicates?
Sure, I have to see what my YD7001-E indicates
Thank you so much.
Greetings,
Mario

I hope this helps. From what I can see the PC and the YD7001 are on different networks. The PC is 192.168.1.80 the number one being key here. Also the PC address is manually being assigned by the PC not the router.

The YD7001 looks to be using a router assigned address 192.168.0.94 the zero being key here.?

Are the PC and the YD7001 plugged into the same router? If they are then the PC setting needs to be changed to allow the router to assign the network. If you need a constant address for configuration files and itrain then you can change a router setting to assign the PC the same address each time.
--
Mike's Deep Run RR
Virginia USA

YD7001 command station
DR4024 servo switchers? DR4088LN-CS DR4088CS
DR5013 reverse loop? DR5033 boosters
JMRI/CATS and Enet loconet connection

Good afternoon.
The idea is to connect directly from the PC's network card to the YD7001-E without using any router. I have seen somewhere that no crossover cable is necessary but I don't know what I should modify to connect the LAN that way, directly with the cable.
Thank you very much for your help.

?

The link is an auto-translated page from our user's Wiki Pages: ?

Greets,

Karst

Thank you very much again for your help.
Just one more question if you allow me on this topic, what do you advise me to control the model, through USB or LAN cable?
Mario

USB if the cable length is <= 2 meters?

I just tried what the link indicates and everything works correctly.
Thank you so much.
Mario