开云体育

I have been using the YD6940 3 to 2 wire adapter to power my Tortoise switch machines with the YD8116.

They work well electrically, but I would like some advice on how to best mount the things rather than leave them to dangle in the air.

There are no mounting holes and so something either has to hold it down or use a hot glue gun on it if that's advisable.

I tried some double sided sticky 3M disks but they don't stick very well at all. All of them have come off the mounting board since the wires to the switch machines are relatively heavy wire.

?

Any ideas?

I use the small zip tie mounts that I screw to the bottom of the baseboards and then use zip ties to hold them up. The mounts come with sticky tape but I use the screw hole. Mike?

--

Mike's Deep Run RR
Virginia USA

YD7001 command station
DR4024 servo switchers? DR4088LN-CS DR4088CS
DR5013 reverse loop? DR5033 boosters
JMRI/CATS and Enet loconet connection

I use the small zip tie mounts that I screw to the bottom of the baseboards and then use zip ties to hold them up. The mounts come with sticky tape but I use the screw hole. Mike?

--

Mike's Deep Run RR
Virginia USA

?

?

Thanks for the suggestion. I dunno why I didn't think of zip ties on mounts before.?

On order now.

?

Don't discount hot glue ht glue. It's super easy & I use it everywhere with success.?