I know the correct way to connect the loconet and S88 modules, But is it possible to say have 4 S88 versions of the DR4088 (giving address's 1 to 64 for feedback)??connected to the S88 giving address's 1 to 64 bus on the DR5000 and also the loconet version connected to the Loconet T connection with the Loconet module programed with an address after the last S88 EG address 65 to 80?
my reason for askingthis as I actually have 8x S88 DR4088 feedback modules on my layout but I need an extra 16 address's near the first module for a push button control panel.
As every cable is labeled with module number, terminal and address on the S88's it would be a huge job to go through relabeling everything 16 positions higher.

Yes, you can use both at the same time with no problems as long as your numbers don't overlap.

Ryan

Going back to this old topic of mine would the following work? and how would the addressing on the S88's work in this configuration? Excuse the rough sketch?

开云体育

Thank you Iain that makes sense.

On Wed, Jan 24, 2024 at 11:33 AM, Iain Morrison wrote:

You will need to ensure that you leave enough address space between the YD6016LN ranges to allow for the S88 connections

Basically correct, But s88 adressing on YD6016LN is/can be on a per input individual base ;) s88 no longer need to be consecutive behind the LN-range. Even the LN range is no longer fixed. Any input can have any address.

Cheers,

Karst