YaMoRC-Digikeijs@groups.io

George Wiesner All Messages By This Member #19 Hello I’m new to digikeijs! I have questions I can’t figure out! For now one. Why when I try to program a DR 5033 to I get a timed out? George
Dennis Cherry All Messages By This Member #20 Edited Greeting and welcome to our website. Tell us what procedure you are using to program the DR5033? What do you want to change? How do you have it connected? Dennis Owner and Moderator
George Wiesner All Messages By This Member #21 开云体育 Ok? I have already programmed an address no problem! I’m trying to Configure CV3! I get it all finished with a value of 10 and hit the lightning bolt to program and it starts an the I get a red time out! George toggle quoted message Show quoted text On Mar 20, 2019, at 7:15 PM, Dennis Cherry <dbcherry@...> wrote: Greeting and welcome to our website. Tell us what procedure you are using to program the DR5033 and also what do you want to change? Dennis Owner and Moderator
George Wiesner All Messages By This Member #22 I go to the loconet B tab put in product number-5033 module address 7 CV? number 3 value 10 bolt nothing but time out! I’m trying to make sure all my boosters (3) are programmed the same!? I recently added an addition and decided to run it off its own booster! I keep getting shorts! It was suggested to me that two boosters not set the same way (configured the same can cause a short! That’s why the changes!?

开云体育