开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. YaMoRC-Digikeijs
  2. Topics

DR4018 individual channel configuration

 

Team, CV47 is currently set to 1 (16 permanent on/off). I want to change channels 15-16 to drive a Turnout Motor (preset 6). I think this can be done by keeping CV47=1 and change CVs 127 & 128, correct? If so, to what do I change CV 127 & 128?
 
Edited

it has been a while doing a special configuration of the DR4018/DK50018.

You will need a DR4101 also if it is a 2 wire turnout motor like the Kato or Tortoise motors.

CV's to change:

CV127 = 11
CV128 = 11
CV228 = 128

Output should be #15 & 16

Let me know if this works.

--
Dennis Cherry
Owner/Moderator
 

Thanks for the quick reply Dennis.
I'll give this a try but can you tell me how you determined these values?
I cannot make sense of it looking at the digikeijs manual.
My turnout motors are MTB MP1 and 've seen a number of YouTube videos that show a direct connection to the dr4018 without using the dr4101. Why is the 4101 needed?
Ivor Abiks
 

开云体育

Not need unless you have cobalt turnout
I.


On 4 Feb 2024 01:48, Vinny DeRobertis <vinny.derobertis@...> wrote:
Thanks for the quick reply Dennis.
I'll give this a try but can you tell me how you determined these values?
I cannot make sense of it looking at the digikeijs manual.
My turnout motors are MTB MP1 and 've seen a number of YouTube videos that show a direct connection to the dr4018 without using the dr4101. Why is the 4101 needed?

1 - 4 of 4