?
It is a piece of flattened tube with a 6mm hole in
it.
Looks like it is just pushed into the slot, normally we
would drill the pod and fit a bolt or sometimes just a cable tie but you would
see this from below.
?
You should only need to just pull it out of the
slot
?
Seamus
?
----- Original Message -----
Sent: Saturday, February 20, 2016 4:33
PM
Subject: X-Air Ultralight Aircraft Pod
removal question [1 Attachment]
?
I am currently removing my pod to gain access to change the part of
the frame where the suspension is mounted.
Most of the ?pod it is easy to see how it comes apart but there
is one part I ?cant see properly so I'm not sure the best way to tackle
it.
In the tail section there are two thin ( non structural ) aluminium
tubes which come down and join a lip on the rear of the pod under the tanks.
?I need to disconnect these from the pod.
I can see a rivet but otherwise have no access and cant see what's on
the other side of the lip. ?Is there some sort of fitting on the other
side which needs to be dissembled or is the tube fitted over a bonded in
spiggot and held with the rivet I can see?
Do I just drill the rivet ?
Photo attached ( hopefully )?
Regards,
Jonathan
