开云体育

If I recall, Mine is right at about 650 with jab 2200, built in radio and xponder and mgl Stratomaster efis Tom

Hello again, My X Air Hanuman came in at about 640lbs. I weighed it with: no fuel but oil in the crankcase, vertical speed indicator, air speed indicator, turning Bank coordinator, voltage and timer

my mechanic was able to get most of it corrected by adjusting several bolts rather than bending anything.? It's still a little off, but much better.

Hi Make sure that wheels are as close together as they can by using strap. Then put the bunge on. ----- Upprunalegt skeyti ----- Frá: Justin Gregoris <jgregoris789@...> Til:

Oh interesting - good thing you mentioned this! Worst case when I remove them, I will start with one side only and count the times as I unwrap them.

Attached are the pictures of where.my Bing carb is on my X Air Hanuman with 2nd generation Jabiru 2200

I'm trying my best to understand how to remove the 40mm Bing carburetor on my X Air Hanuman. Does anyone know what parts to remove in order to access and completely disconnect the carb from the

Correct.? 4.5 wraps per front and rear is 9 per side (Left and Right)

Just to reiterate, the way I understand the bungee cord installation according to the manual is about 4 wraps around each fastening bolt, not 9 - is this

Mine are like the ones in the assembly manual.

Yes and replaced with new X-Air bungees.

I have to change my bungees in a few days myself - when you say 9 times, you mean roughly 4 wraps per fastening bolt? Do you use zip ties or heat shrink or some other way to connect the ends

The caution is to make sure any planned structural changes are reviewed with the manufacturer - just because one can doesn’t necessarily mean one should ….. Geoff Gartshore Zenith CH200

Just make a slight bend in a component, while taking in account the additional change once the suspension is ore loaded come time to land ________________________________ Sent: Tuesday, March 8, 2022

Hi Are the bungees wrapped 9 times on both sites? ----- Upprunalegt skeyti ----- Frá: mcressman via groups.io <mcressman@...> Til: [email protected] Sent: Tue, 08 Mar 2022 16:04:19 -0000

I'm probably foing to have to.? There is no adjustment and I cannot find anything that appears to be bent.

Can't you simply Bend something like the left axle forward towards the propeller to compensate for the towel? Or bend the axle towards the front propeller? Something is obviously not at zero

I am having an issue with a toe out situation on the left wheel.? I have replaced bungees with factory originals and axle assemblies on both sides but the problem still exists.? Any ideas?

Good day everyone, Has anyone installed bubble doors on their X Air? If so, what was the increase in cabin width from the original 43 inches? Did any parts from the original OEM door? that was

cruise is 70 knots IAS & fuel consumption is around 14 litres per hour ________________________________ Sent: February 22, 2022 8:24 AM To: [email protected] <[email protected]> Subject: Re: [XAIR] New