开云体育

Hi all,
I had the problem to control my tuner via flrig on my HamPi. My flrig let me only switch the frequency or modulation.
I couldn?t find a documentation of the CAT commands for the X5105.
The only docu I found was here:?
which is the docu for the G90.

But you can use it for the X5105 too. You only need to switch the bit x88 to x70 and it works for me!

Example:
Start auto tune on G90:?xFE xFE x88 xE0 x1C x01 x02 xFD
Start auto tune on X5105:?xFE xFE x70 xE0 x1C x01 x02 xFD

You can add the config strings simply in the commands tab and give the command a name. Done.
Most of the commands for the G90 works on the X5105, too.

I hope, I could help someone with this hack ;)

I have read that Xiegu radios use the Icom CAT commands language, and the article suggested setting the IC-7100 as the radio.? That works for my X5105.?? (It does not work for programming memories or messages, though.)

I have also, more recently, set the "RIG" as G90, and that works for 'basic' commands like frequency and 'transmit'.? I use only FT8, so I don't need very many CAT commands.
--------
Doug, K8RFT