开云体育

If the Batterie of the X5105 is fully discharded, the Radio wouldnt turn on aigain. You need to charg the X5105 fully (12Hours) befor you can turn it on again. It looks like Broken in this status but

Hi JP, No, none of my triage attempts via the menu settings/connectors worked. I will try to tighten the standoffs as you prescribed in detail in your other email, as that path makes sense to me.

Steve, Were you able to the radio working? JP KA3BWP

Lou, I did not improve per se, I merely tightened the screws holding the brass standoffs with screw stick & needle nose pliers. The standoffs are knurled so easy to grip. I did need use a pair of

Hi JP, Great question! Yes, I did change the mode and key down but, quite honestly, thought that the programming of the rig would prevent output in those modes when keying the rig as the primary

Thanks for your insights Doug. Yes, I’m afraid at this point it could be internal/hardware. I was trying to eliminate all user/menu/software issues before diving into the innards. I exhausted my

Lou, Have you tried switching mode to FM and keying microphone to see if it’s a CW only issue? I ask only because I had similar issue & it ended up being traced to the loose brass board standoffs

It sounds like it could be a temperature-sensitive solder joint on a PC board.? Or, less likely, I think, a temperature-sensitive component (resistor, capacitor, etc.) Great job of documenting your

I have an X5105, FW Version 3.0. The latest chronic issue that has worsened with use is intermittent transmit in CW Mode. Simply put, when the unit is placed into CW Mode and a key (paddle or SK) is

I used my X5105 on FT8 a couple of years ago.? It worked well enough, but it did take some effort to get the cabling right, and I did have more trouble trying to get it to work with the DigiRig cable

In case anybody in the group is using the x5105 for FT8 here is my ultra portable setup using the FT8CN app for Android phones, in my case a Samsung Note 8. I was able to achieve simultaneous CAT,

Sharing tips and info - This is why we have the group! -------- Doug, K8RFT

Thanks to DougVL and riushr for the cable trimming advice.? Seems to have done the trick. Took a little patience with a utility knife and a magnifier but it works now.

Yes it is a known issue on the 5105. I trimmed the plastic around the end of the connector and that solved the issue. Im using an XGG.comms interface. Sent from my POS LG phone. Real radios glow

That could be the issue. It never did seat very snuggly. Thanks.

By the way, welcome to the group! And, I had the same problem, with the plug not quite fitting far enough into the jack.? Trimming about 1/16 inch, or maybe slightly more, off the plastic around the

Plus, at one time, someone else posted a similar problem, and its cure.?? If you look through the old messages, you should be able to find one with photos of the fix. -- -------- Doug, K8RFT

The X5105 is known for having slightly non-standard jacks.? The plastic around them is a bit thick, and often the plastic around the mating plug (on the cable) needs to be trimmed back a little so

Has anybody experienced connection problems with the ACC port using the 8 pin din to trrs cable for ft8? I was having intermittent interruption of the decode and transmit audio and solved it by

If I set my X5105 to FM modulation, the transmit frequency is about 6.8 kHz lower as shown in the display. For example, the Xiegu shows the frequency 29.160 MHz in the display, the real transmit