开云体育

I do not know if this has been covered yet but can the repeater operate in analog mode also or does the audio routing prevent that? Also if programmed though pi star could you also do P25? I have

W6CX has not enabled analog FM as another mode on the W6CX DV repeater at 145.0, but the G4KLX suite of DV program now supports that. Our club already has a really good analog FM 2 meter repeater.

Info about an interesting open source project targeting a wide range of RF configurations, including amateur radio: The following is from https://www.crowdsupply.com/lime-micro/limesdr#products --

The BIG limitation on LimeSDR at the moment is availability! Also from Crowd Supply in the same listing Jim quotes above: "End of Life Announcement"

When power came back, our Digital Voice repeater on 145.0 failed to come back online. The Pi that controls it did come back and is functioning, but the RX and TX radios did not power up when power

This note is for people who registered their callsign for D-STAR on the W6CX D-STAR gateway. If you need to modify your D-STAR registration info, that has been moved to the REGIST gateway which is

Info. For most hotspots, it may take a day or two for your network to pick up the new IP address. Or, you can reboot your hotspot’s computer and it should be able to access REF014 reflectors again

The W6CX Digital Voice repeater is now linking correctly to the new REF014 reflector - the West Coast D-Star reflector. Our DV repeater has traditionally default linked to that reflector,

The digital voice repeater is temporarily down. Trevor and I went up to the site today to reconfigure the radios so if the UPS or generator were to have problems again and lose power, the DV radios

The digital voice repeater is temporarily down. Trevor and I went up to the site today to reconfigure the radios so if the UPS or generator were to have problems again and lose power, the DV radios

Thanks Jim for all you do for all of us. Great job. Stay warm. Stay dry. Stay well. Have a great year 73 Ralph K6RAA

Ralph, Thanks. Trevor and I are headed up to the site Thursday morning and hopefully will get W6CX-DV back on the air then. There was a light dusting of snow up there, with a bit of ice on the

Trevor and I went back up to South Peak today and discovered the 12v power cable to the RX and TX radios used by the digital voice repeater had an intermittent connector. It had worked ok after we

Today we noticed the W6CX digital voice repeater was not receiving, though the transmitter was working fine. The problem was reported to Trevor WA6JAU (MDARC's South Peak site manager), who

Trevor WA6JAU and Jim K6SOE made the trip up to South Peak and just finished reconfiguring the antenna for our MultiMode repeater. D-Star, DMR and C4FM/Fusion are all working again. Thanks!

Are you sure that the D-Star, DMR and C4FM/Fusion are all working again because when I key up with DMR I get a “Repeater Not Found” message. Thanks, LarryB, KK6QPE Sent: Friday, January

I am getting the same thing here. I was able to get into the DV repeater, just not so well from south of the tower, but now I cannot get in at all. I got a note from Trevor about problems with the

Larry At the present time the D-Star, DMR, Fusion system is turned off. A combiner on Mt. Diablo went bad and was affecting receive sensitivity on 2 meters. I am trying to find a correct combiner to

Thanks Trevor for updating us on the status of this repeater. LarryB [email protected]> wrote:

Is the status still the same, digital modes turned off? Jay KE6GLA