开云体育

Are you sure that the D-Star, DMR and C4FM/Fusion are all working again because when I key up with DMR I get a “Repeater Not Found” message. Thanks, LarryB, KK6QPE Sent: Friday, January

Trevor WA6JAU and Jim K6SOE made the trip up to South Peak and just finished reconfiguring the antenna for our MultiMode repeater. D-Star, DMR and C4FM/Fusion are all working again. Thanks!

Today we noticed the W6CX digital voice repeater was not receiving, though the transmitter was working fine. The problem was reported to Trevor WA6JAU (MDARC's South Peak site manager), who

Trevor and I went back up to South Peak today and discovered the 12v power cable to the RX and TX radios used by the digital voice repeater had an intermittent connector. It had worked ok after we

Ralph, Thanks. Trevor and I are headed up to the site Thursday morning and hopefully will get W6CX-DV back on the air then. There was a light dusting of snow up there, with a bit of ice on the

Thanks Jim for all you do for all of us. Great job. Stay warm. Stay dry. Stay well. Have a great year 73 Ralph K6RAA

The digital voice repeater is temporarily down. Trevor and I went up to the site today to reconfigure the radios so if the UPS or generator were to have problems again and lose power, the DV radios

The digital voice repeater is temporarily down. Trevor and I went up to the site today to reconfigure the radios so if the UPS or generator were to have problems again and lose power, the DV radios

The W6CX Digital Voice repeater is now linking correctly to the new REF014 reflector - the West Coast D-Star reflector. Our DV repeater has traditionally default linked to that reflector,

Info. For most hotspots, it may take a day or two for your network to pick up the new IP address. Or, you can reboot your hotspot’s computer and it should be able to access REF014 reflectors again

This note is for people who registered their callsign for D-STAR on the W6CX D-STAR gateway. If you need to modify your D-STAR registration info, that has been moved to the REGIST gateway which is

When power came back, our Digital Voice repeater on 145.0 failed to come back online. The Pi that controls it did come back and is functioning, but the RX and TX radios did not power up when power

The BIG limitation on LimeSDR at the moment is availability! Also from Crowd Supply in the same listing Jim quotes above: "End of Life Announcement"

Info about an interesting open source project targeting a wide range of RF configurations, including amateur radio: The following is from https://www.crowdsupply.com/lime-micro/limesdr#products --

W6CX has not enabled analog FM as another mode on the W6CX DV repeater at 145.0, but the G4KLX suite of DV program now supports that. Our club already has a really good analog FM 2 meter repeater.

I do not know if this has been covered yet but can the repeater operate in analog mode also or does the audio routing prevent that? Also if programmed though pi star could you also do P25? I have

Roger, (I’m copying this to MDARC’s digital voice forum also.) I just checked at https://dstar.info/query.html and see your callsign is properly registered for D-Star. So you are in good shape

Hi Jim, Thank you for your reply; I never thought about linking restriction due to bandwidth issues; that does make a lot of sense. Thanks too for the overview of the gateway software and pointing

<https://r20.rs6.net/on.jsp?ca=4e891674-812d-4e27-a3f9-2f699e32a093&a=1131514436760&c=bdd452a0-e9d3-11e8-a06d-d4ae5291bfcb&ch=bf50e080-e9d3-11e8-a073-d4ae5291bfcb> I am not endorsing and

John, Very interesting post. First, I’m glad you are making use of sending radio commands to link the W6CX DV repeater to various D-STAR reflectors or repeaters. MDARC encourages users to make