开云体育

Ah well, I forget that some here may not have had the benefit of Mert's practical advice. Essentially it is a bit like the thread follower threading that can be used on Unimats, but instead of the

In my last post I forgot to mention that I have the tap also. -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113

Keith, that is exactly what I intend to use. Dick -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113 (

Oops… Not ‘headstock forward’ of course but ‘three jaw chuck forward’ (or whatever is being used to hold the work)

I think Keith might mean to put a thread up through the piece and (as these earlier Unimats have a sliding quill in the headstock) use a bolt in the fixed tailstock to rotate the headstock forward in

Mert Method? Would you have a link that explains that method, Keith? Verzonden vanuit Outlook voor iOS Verzonden: woensdag, januari 22, 2025 7:57 AM Aan: Peter Brooks

You could use the Mert Method with an M10 (× 1.5) bolt as a guide.

Sounds good. How are you planning to cut the thread on your holder? I think it might be M40 x 1.5, pretty chunky! As John said, it would be great to see some photos of the work in progress.

Nice.? Looking forward to photos of that.

I removed most of dial hand wheel lash on my Unimat DB200 by adding a thin washer behind the handwheel. Lash now only about .002” which is very tolerable. After the adjustment I am now ready to do

Has anyone made actually maderesettable dials for the Unimat SL/Db? -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/

Thank you, Peter! -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113 (

Good pic! (Sorry, I thought you might have used email… as they say, all’s well that ends well…)

-- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113 (

Peter, what is the email of this group? I just go to the Unimat group. I am unaware of any email address. -- http://www.homemadetools.net/ forum/ OFF-

Do you use email to post to the group?? If so, have you tried just attaching the photo to your email, or (if your email software is very graphic) inserting it into your email? (I use the web page

I have a nice photo! How do I send a photo to the Unimat files? I know I have done this in the past but don’t remember how. -- http://www.homemadetools.net/ forum/ OFF-

Peter, I will take some pictures later today. Dick -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113 (

Any photos Dick?

Thanks, John! I will look into it! Dick -- http://www.homemadetools.net/ forum/ OFF- SET-tailstock-center-65965#post105972 http://www.homemadetools.net/ forum/s...995#post112113 (