A downward slant suggests a vertical misalignment. That is difficult to
adjust on the Unimat as they are not designed for vertical adjustment.
Also, there are several places that may be causing the misalignment, if
that is the problem.
Elliot
toggle quoted message
Show quoted text
On 6/21/23 5:39 PM, Richy Russo via groups.io wrote:
Thanks!
? My problem is I was drilling thru a brass rod to make it a fuel tube
for an SU carburetor. It was approx 2 inches long. I started with a
small pilot, but as I moved up in size I noticed it was drilling into
the workpiece on a downward slant. I was able to complete the process
and make it work. But I asked here because I would like to correct it. I
did manage to get it a little closer messing with the headstock.
? Regards Richy
--
Elliot Nesterman
elliot@...
www.ajoure.net
"The finest jewel cannot disguise a flawed character."
