Keith,
I contacted KB Electronics by phone today and was advised directly by a customer service manager that I cannot run a 24 volt dc motor with the KBMD motor control I have. There is no way to get the output voltage down to 24 volts. Now that I know that, I will need to buy a 24 volt DC power controller which is available on EBay I am told.
I will buy the motor today and search out a controller for a 24 volt dc motor.?
Does it make any difference if I use a ¡°brush¡± or ¡°brushless¡± motor?
--
http://www.homemadetools.net/forum/?OFF-SET-tailstock-center-65965#post105972
?SMALL TURRET TOOL POST PLANS?
?LARGE TURRET TOOL POST PLANS
?MINI-LATHE CARRIAGE LOCK PLANS
?SMALL QC TOOL POST PLANS?
?QUICK CHANGE LATHE TURRET
?MINI LATHE COMPOUND PIVOT MODIFICATION
OldToolmaker