开云体育

Hi Herbert, The confusing situation is that there were two different probes (a voltage probe and a current probe) with the same number P6022. Maybe not at the same time. Last mention of the voltage

I have an opportunity to get either a 454 or 465. Spec wise, either will meet my need, both are working and there is no difference in cost. From what I have read, the 454 contains no proprietary parts

Hi Albert, it is a current probe, for use on 1MOhm inputs with and Bandwidth equal or larger than 300 MHz. 1mA / 1mV (8,5kHz - 100 MHz) 10mA/1mV (935Hz - 120 MHz) usefull for development in switched

It's a DP-100 Digital Video Probe in mint condition. It works in TM500 or TM5000 frames. I don't have a P6454 or P6460 to go with it, but I see that QService currently has a P6460 available. "The

Thank you for the information - that's kinda what I expected but I wanted to make sure. Thanks again. Mike

I have seen this on a couple of different instruments lately so I think it might not be that uncommon. I am referring to the gray-levered three position slider switches on 2213's and 2235's (probabl

Add international shipping option, and you're all set. I'll take a 485, or 475 for the right amount.

I have three probes that came with the 475. The first one is a Tektronix with what appears to be a 013-071 screw-on tip. The ring of the probe handle shows 10003A, 600V Max, Atten 10X, 10 Megohm, 10

Hello, I tried to seach info about tektronix CSA series on Google, but found few. They seem to be somewhat similar to 11k series mainframes, I'd like to know more about them, I'm curious to know what

P6022 at Tektronix Catalog 1962 page 192. Albert

The same number P6022 has been used for a voltage probe. Mentioned for instance in the passive voltage probe overview at Bill & Stan's Tektronix Resource Site. Albert

Anybody has a spare tektronix 475 or 475a case, with handle, that is willing to sell ? The tektronix 465 or 465b case is also suitable.

Chris The problem could be in the 87V regulator Or Their could be a short/low Resistance some where in the load I have a 2465B open and I measured a load resistance of 25.3K to ground on Pin 7 of J121

Hi, ehm, before I wrote r296 but I meant r294.... Giampi

Hi, yes, r296 connected to the cathode of cr196, is 2.7K 1/4W 5% Giampi

Hello Walter.How much do you want for a Tek 11 K Mianframe with coror tube ( Or Display Unit )Regards Jan Koria Tech Test Equipment Services.

Richard, The Tektronix P6009 probe is rated up to 2.1kV peak (1.5kV rms, 4.2kV p-p), but not at full frequency. It is derated to 1000V peak in the 3MHz to 6MHz range, and 200V peak at 30MHz. These

Whatever probe you are using, you need to get the manual for it. The voltage limit decreases with frequency. Usually pretty quickly. For example, at DC your probe might be rated for 500 volts. At 30

Richard, ? Suggest you review a couple of web articles before digging into the rig with scope.? Typically if your trying to observe RF at the plate tank, there should be a RF sampler which brings

I have a 475 scope, but pretty much a beginner in its use. I want to measure RF frequencies in a ham tranceiver that could be as high as 800 VDC, and up to 30 Mhz. My question has to do with the