开云体育

Does anyone have a 067-0521-01 that they don't need anymore? I see a couple on the famous auction site but the prices seem excessive. (even compared to recent historical pricing)

Hi, why not check feedback resistor R1589 47ohm and also R1571 10k, C1571 100p. G?ran

I started looking at the vertical interface board and how the 7A18s could not work here while 7A26s are fine, then took some wild goose chases that were dead ends. I decided to make sure it was the

I'd like to have some of those boards. I have two 7A13s and would like to replace all the relays. I also have a 7A12 which uses 8 of them. In addition I need two of the "polarized" relays

They operate a test equipment calibration service and sales from a brick and mortar so it's a step up from an ebay seller but yes that price is still absurd for what it is. What drives me nuts is that

I'm certainly interested, at least in the PCB. I've actually been having this same battle with a 7A13 this last week, and was getting read to ask the list if anyone had published a PCB adapter since

Typical eBay seller. A $13,000 device, $1000 for shipping , one picture and description copied from the brochure. Anybody who would spend that kind of money based on the listing gets what they

The following photos have been uploaded to the Tek 148-003x-00 relay replacement ( /g/TekScopes/album?id=299851 ) photo album of the [email protected] group. *

Hello again, after sending the message I saw that I forgot the most crucial part in my BOM. 1x Relay (IM06TS) 1x Diode Array (BAS40DW-04) 0.1x Pin Header (W+P 952-09-080-2 cut into 10 pieces) 1x

Hello all, after quite a few years of absence from this group and from my trusty 7000-series equipment, I am back. The reason is quite obvious. I have a special measurement job which needs my

I NEED TO NO A RESISTOR VALUE IN THE RCTIFIER BOARD FOR THIS SCOPE MINE IS ALL BURNED UP ANE I CAN'T FINE THE HV OSCILLATOR TRANSISTOR. THANKS JOE

That seems highly likely. It might have been used to test SD sampling heads and the panel connections are from the interface to the heads.

Could this be for someone at tek to do maintenance on SM11 boxes? <clarkfoley@...> wrote:

They appear to related to Option 1M. I suspect someone needed to access the rear connections to the SM11 box and found it more convenient to patch them to the front. A simple unauthorized DIY mod to

That is truly bizarre!? Hard to imagine why somebody would need, or think he would need, that many connectors! Jim FordLaguna Hills, California, USA

Like this: https://www.ebay.com/itm/404611781733

The listing has ended. I would like to have seen the unit.

Hi Folks, I just noticed this unit on ebay. The front panel has a whole extra array of connectors there. https://www.ebay.com/itm/296917599623 Does anyone know what these were for? -Evan

Hi Guys! I use to say that my books activity is 100% non-profit, but I was wrong. When you are so kind to appreciate my work I get my salary! Thanks and best wishes (I will post soon a draft of

The following photos have been uploaded to the JFETs substitution for 12au6s in 575 curve tracer ( /g/TekScopes/album?id=299769 ) photo album of the [email protected] group. *