Ron,
Try this exercise to see if this clears up your issue. Its a specific button push in the correct sequence.
CYCLE ERROR CLEAR (Exerciser 03). This routine
provides a way for the operator to clear the cycle-failure
data written to the RAM when a CYCLE mode failure
occurs. Interpretation of the cycle failure data is explained
in the "Display Format" description provided earlier in this
section. Until the data is cleared, each time the
instrument is powered up, the Diagnostic Monitor is
entered.
Clearing the RAM location (and the CYCLE ERROR
message) is done by scrolling to EXER 03 (CLEAR CYCLE
ERROR) and pressing the following switches in sequence:
TRIGGER COUPLING upper (starts exerciser),
TRIGGER SOURCE lower,
TRIGGER MODE lower, then
TRIGGER COUPLING lower (exits the exerciser).
When the CYCLE ERROR CLEAR routine is successfully
executed, the cycle failure data will disappear from
the display.
Craig Cramb