开云体育

Yes I mean off groups. dumon@... ( dumon@... ) Thanks,

What's your address... off groups? I only have the mains. Mike [email protected]> wrote:

I would be interested, could you email off line with your price and address so I can figure out shipping?

I have gear legs from an RV7A if interested. [email protected]> wrote:

I was browsing my aviation YouTube channels and came across this website mentioned on Cleared Direct.? It is https://www.flysto.net/ (

Hi, its Adrien here up in Regina Saskatchewan Canada. I'm building a W10 trike. I have emailed Langair a few times and requested a quote and also tried phoning. No response, is there a trick to get

Good to know, thanks for the info. Mike [email protected]> wrote:

If you are ordering a set of custom gear legs, be aware that the 1 1/4" axle size is"nominal". If the axle is made to that exact dimension the wheel won't fit. The axle needs to be a couple of

I'm using it on a light W8. [email protected]> wrote:

I can’t answer for all, but these that I just checked are 1 ?” Red Sent: Saturday, April 5, 2025 2:09 PM To: [email protected] Subject: Re: [TailwindForum] Harmon Lang gear Axle

W8 and W10 both 1 1/4 axle diameter. W8 is 3/4" diameter at the small end of taper, recommended to use 7/8 for W10.?

I think so, I can verify that on these and report Red Sent: Saturday, April 5, 2025 2:09 PM To: [email protected] Subject: Re: [TailwindForum] Harmon Lang gear Axle sizes on all W8s and

AmSafe 5-point restraint system, with inertia reels and locking lever. Qty 2, Conforms to FAA TSO-C114 (pilot and co-pilot). Locking levers can be disconnected. Color black. Rated 3000 lb. Price $500

Axle sizes on all W8s and W10s were 1.250", right? wrote:

SOLD!

OK, do we have your address? Red Sent: Saturday, April 5, 2025 1:34 PM To: [email protected] Subject: Re: [TailwindForum] Harmon Lang gear Red, I will take those. Mike

Red, I will take those. Mike wrote:

I have a pair that would be good for a W-8, $150 plus shipping at cost. Please reply off forum, Red Sent: Saturday, April 5, 2025 11:52 AM To: [email protected] Subject: Re:

Dan. W8 or W10? [email protected]> wrote:

Hello Group: For Sale never used/not drilled. $650 plus UPS from 52205 Anamosa IA. Tell me what your ship-to address is and I will extend my UPS discount to you.