开云体育

Yes Rick T27Owners@...> wrote:

Do you still have the sails . (De Luna #167) kpcola@...

Here is an example of modifying a boat for a pocket transducer install, https://www.thehulltruth.com/boating-forum/924797-diy-cm599lh-pocket-mount-transducer.html I think the photos are a bit out of

I need the steaming/deck light. With a working bulb. Not able to replace the burned out bulb . The bulb size has been changed and no longer fits the holder. t27-2 hull 700. Thanks Robert Sent from

If I install the new sensor where the old one was, then I do not increase the total number of holes in the bottom. If I don't install it there, then I have to fiberglass over the hole that is already

The lead pigs are probably original. The early T27s were tender and had 400 lbs of these pigs. Number 90 has them. I’m giving some thought to pouring some concrete, maybe with lead shot, into the

Ah, OK. I misunderstood, even though your post was clear. Insufficient caffeination on my part. Apologies. You ARE planning on cutting a biggish hole and want a flat spot on the outside of the hull

Hi Monica. I'm at 19 Sunwoods Circle, Hamden, Ct.. You had contacted me on some other items like a table, cushions, stantions, etc.. Thanks, Rick [T27Owners] <T27Owners@...> wrote:

Is it directly on the center line? Or offset a bit? I've been thinking that might be where I want to install mine (a DST800). Mine is currently temporarily mounted underneath the icebox. But if I am

Mine is forward between the mast and V berth under a hatch in the sole on center line. It is depth only and goes through the hull. I have no idea how old it is, was there when we got the boat. Fred

My impression is that the face of the transducer is still in direct contact with the water. It's just that the boat builder was nice and created a nice flat area for you to mount the transducer. I

That ‘pocket’ concept is very interesting. Would that be hollow, i.e. a fairing applied to the hull with an air space between the hull and the outer skin of the fairing? Or does that hollow area

I temporarily mounted my DST800 triducer on the port side under the icebox using a blob of wax from a toilet bowl wax o-ring. It's kind of like sticky playdoh. I've been using it that way for the last

At one point they came with metal cradles that could be used on the ground or mounted to a trailer. I am not familiar with the wooden ones. Houston is a little out of my pickup range. I'm in NJ.

In Houston, What part is this? is it for a trailer?

Where are you ?

I mounted a very old one in the port settee locker using butyl tape and it seems to work fine. The display is large and I mounted it to the side of the icebox, next to the stairs facing up. So you can

I still have my wood frame from my T27 and anyone is welcome to it for free. It's functionally incredible.

Thanks for the information!

I did the job last year. Located it st the center of the forward part of the hull. Needed to be level though. Sent from Yahoo Mail for iPhone