开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. SouthBendLathe
  2. Topics

Request for dimensions

 

Hello...Brian aka ka9egw aka lurchix aka Lurch here.? After a number of years' hiatus, I have time to get out to the shop again.? i have two micrometer carriage stops for my 10K, a lefty and a righty, neither of which has the bottom plate ['clamp'] which I believe to be PT1201NK1.? I've looked all through the files section but pulled a blank...i just need to know the dimensions.
Thank you in advance
Lurch
 

I don't have a micrometer stop, but I have one of these.? If the plate looks?like it'd work for your stops I can sketch up a drawing.



On Mon, Jan 1, 2024 at 10:49?AM Brian <ka9egw@...> wrote:
Hello...Brian aka ka9egw aka lurchix aka Lurch here.? After a number of years' hiatus, I have time to get out to the shop again.? i have two micrometer carriage stops for my 10K, a lefty and a righty, neither of which has the bottom plate ['clamp'] which I believe to be PT1201NK1.? I've looked all through the files section but pulled a blank...i just need to know the dimensions.
Thank you in advance
Lurch

 

Mine is for a 10k, btw, just using the listing to show the general thing.


On Mon, Jan 1, 2024 at 11:24?AM Rogan Creswick via <creswick=[email protected]> wrote:
I don't have a micrometer stop, but I have one of these.? If the plate looks?like it'd work for your stops I can sketch up a drawing.



On Mon, Jan 1, 2024 at 10:49?AM Brian <ka9egw@...> wrote:
Hello...Brian aka ka9egw aka lurchix aka Lurch here.? After a number of years' hiatus, I have time to get out to the shop again.? i have two micrometer carriage stops for my 10K, a lefty and a righty, neither of which has the bottom plate ['clamp'] which I believe to be PT1201NK1.? I've looked all through the files section but pulled a blank...i just need to know the dimensions.
Thank you in advance
Lurch

 

That looks awful close, yep.? I think it's wider because the 4-position stop is wider, but the critical dimension I need is the height of the ledge.? The ledge-to-hole[s] distance will be determined by measuring the micrometer stop so the rest I can figure out based on my scientific method [read: "what's in the scrap bin that looks close?"]..? Thank you!
 

I'm sorry this took all day.

Mine doesn't have a ledge, it is just a bit of flat bar with a clearance hole, a threaded hole, and an aesthetic taper.

Hopefully these dimensions help, though, and let me know if there are other details?you need.

--Rogan



On Mon, Jan 1, 2024, 11:40?AM Brian <ka9egw@...> wrote:
That looks awful close, yep.? I think it's wider because the 4-position stop is wider, but the critical dimension I need is the height of the ledge.? The ledge-to-hole[s] distance will be determined by measuring the micrometer stop so the rest I can figure out based on my scientific method [read: "what's in the scrap bin that looks close?"]..? Thank you!

PXL_20240102_052521918.jpg

1 - 5 of 5