开云体育

Some more pics.

[email protected] All Messages By This Member #49 Hi all, I hope everyone had a Merry Christmas. I have a a page dedicated to my South Bend 9" workshop lathe, there is not much there but at least you can see a couple of pics of another lathe. Also, I am storing this lathe until make a decision on keeping it and I was wondering if I could use those machinery mounts I found in the Grizzly catalog instead of bolting down this lathe? I can't bolt it down where I have it stored at. I tried one day to turn a small part just to see it run but it vibrated to much. Thanks, Dean http://members.aol.com/_ht_a/vwone/myhomepage/profile.html Just click on My South Bend Page. ??
Paul R. Hvidston #50 开云体育 Dean, ? Nice looking lathe. Could you tell me the diameter of the pulleys on the motor and at the top of the jack-shaft (the red ones)? I may need to duplicate those. ? Thanks ? Paul R. Hvidston Upland, CA toggle quoted message Show quoted text ----- Original Message ----- From: VWONE@... To: southbendlathe@... Sent: Tuesday, December 26, 2000 11:35 AM Subject: [southbendlathe] Some more pics. Hi all, I hope everyone had a Merry Christmas. I have a a page dedicated to my South Bend 9" workshop lathe, there is not much there but at least you can see a couple of pics of another lathe. Also, I am storing this lathe until make a decision on keeping it and I was wondering if I could use those machinery mounts I found in the Grizzly catalog instead of bolting down this lathe? I can't bolt it down where I have it stored at. I tried one day to turn a small part just to see it run but it vibrated to much. Thanks, Dean http://members.aol.com/_ht_a/vwone/myhomepage/profile.html Just click on My South Bend Page. ?? `To unsubscribe from this group, send an email to: southbendlathe-unsubscribe@...`

Previous Topic Next Topic