开云体育

Hello! We do not recommend using Arduino to update the AA-30 Zero firmware. Use any USB-to-UART adapter (better based on FTDI chip). /Best Regards, Alex/ // 07.10.2020 17:44, Jonas Calhoun via

Dear Roy, A return loss of 80 dB is a "math joke" as I said. The real dynamic range of the analyzer lies at the level of 44-50 dB. Pay attention to the level of return loss reported by *Anritsu *and

Going from 1.0002 VSWR to 1.016 is quite a difference. Does this mean that my RL measurements can be off by approximately by 38 dB?

I’ve never been able to do an update via the Uno, I’ve had to always connect directly to the Zero through an FTDI cable. Dan

So i saw there was a update, decided to use the update flash tool, it failed and now i cant even use the Zero. I was using the Arduino Uno and it was working fine until i did the update.? Odd that it

Hello Roy, There is nothing strange about this. When you perform a calibration, you pass the dummy load parameters to the analyzer as a reference. And when, after calibration, you measure the

No matter which OSL or 50 ohm load I use for OSL calibration, the measurements are coming back with crazy high values. Using the SWR meter, the return loos reading jumps all over the place. Using an

Tim. Manuals and software for the AA-600 can be downloaded here: https://rigexpert.com/products/antenna-analyzers/aa-600/downloads/ VE7DXK

Hi Alex, thank you, muchly appreciated . Cheers Tim.

Hi Tim, Try pressing the *F*//and the *up arrow* (*or down arrow*) buttons at the same time. /Best Regards, Alex/ // 03.10.2020 5:21, Tim Jones пише:

Hi all, having recently purchased a 2nd hand AA600 I wonder if I could ask for assistance? How do you change the SWR scale? Currently only shows a maximum of 2 on the vertical scale. Is it an easy

Here is some more information on this problem for those interested.? I used a Bluetooth Protocol Analyzer to monitor the traffic going from my AA-55 Zoom to an Android Tablet.? RigExpert sends the

The RigExpert Analyzers work well for measuring antennas but you can also use them to measure components like inductors or capacitors.? What is required is a suitable test jig.? When I want accurate

Amigos, gracias! ?Ten un buen fin de semana! / //Saludos, Alex UR4MCB/ // 24.09.2020 18:37, Hoc LU5BE пишет:

Alex is the best OM!!! He fixes everything and fast. Admirable. I congratulate you! Enjoy our Rigexperts !! LU5BE Horacio http://lu5be.blogspot.com.ar/ ________________________________ De:

Hola Alex, moltes gràcies per resoldre el problema, funciona la primera vegada. Vaig passar moltes hores provant una solució, però la vostra, en menys de 5 minuts, ha funcionat. Aconsello a tothom

Dear Mr. Torres, Windows 10 has very strong protection and is suspicious of software and drivers not approved by Microsoft. To correctly install the drivers for the TI-5000 interface, you must

Recently, I have renewed my computer, with Windows 10 and I cannot correctly install the drivers for my Rigexpert TI-5000, these with the previous version of windows 7 worked wonderfully. The problem

It seems a few of us are having problems with Bluetooth on our RigExpert? analyzers.? I saw the comments below on the RigExpert Facebook group.? I am surprised that RigExpert does not respond to my

Hello, I have a similar persistent problem (going on for over half a year, also posted on this forum and still with no solution) regarding the AA-230 ZOOM and Bluetooth. In my case phone (Galaxy A70)