开云体育

There was a place here in the US that was factory service. From: [email protected] <[email protected]> On Behalf Of Carl Juvrud KP2L via groups.io Sent: Thursday, March 6, 2025 4:52

Hello, I have a AA230 zoom analyzer with problems.? It now shows infinite swr on all bands with a small 50 ohm dummy load.? Have tried firmware update, calibration, and self test, all to no avail.?

The measurement made is the electrical length.? The conversion to physical length is done by using the velocity factor that you entered.? Yes there can be a difference between the actual velocity

I have a few questions re the cable length function.? Does it measure the actual length or the electrical length?? I know that there can be differences between the published velocity factor for a

I've had the AA-230 ZOOM for several years so the only means of connecting it to the computer is with a USB cable. I see that Antscope2 is now offered in .deb packages which do install cleanly on

HI Yuri, I closely examined all the resisters in question under a scope and there are no physical signs of any issues. I did order the replacement resisters but I have to reconstruct the schematic

Hi Dennis. If you are failing Resistive Bridge Test (Self Test #1), I would start with opening the rear cover and examining 7 bridge resistors. Usually it's the first 2 that got fried from RF or

My AA-230 Zoom failed 13 days past the 2 year warranty and I was told it was probably caused by static discharge and the 7 bridge resisters and possibly the HF switch IC may need to be replaced.? The

Additionally, If I boot a Win10 VirtualBox guest on that same laptop running Mint natively and attach the AA-1400 to the running Windows guest and then run AntScope2 (v1.3.7) for Windows and select

Hey all.... I just installed AntScope onto Mint Linux (Ubuntu variant) -- and while AntScope scans and gets a response from the AA-1400 when using COM as the device category, the fields don't populate

Must have been Op error, because now it’s working as advertised. Did contact Rig Expert Support and they did answer asap. Sent a video.. so good to go on this end. Tnx for replies 73 Paul W2ECK

Paul, After taking a measurement, to save the results, you only have to push [6]. Do NOT push the F button. THEN it will work. 73, Rick, DJ0IP (Nr. Frankfurt, Germany) May the Sunspots be with us!

So that is not working on mine? Paul

I just checked mine.? My previous post was wrong.? You don't press F -> just 6 to save and nine to load. Roger

Yes . I press F and 6. Hear a beep but screen does not change to the save location screen. Same if I press F and 9 key. 73 Paul

Are you pressing the F button in the bottom left hand corner and holding it down when you press the 6 button? Roger

I have an AA-55 Zoom that I can not get the Save or Retrieve functions to work- as described on page 10 in the manual. I take a reading, then press 6 to save it and nothing happens. Same if I press 9

Yes, I have the Rigexpert AA35 Zoom, but I can't read it in the sunlight, I like the MFJ 259D outdoors, I live in Florida, strong sun. No problem reading that,also try a Tiny VNA, inexpensive and very

Why not just shade the analyzer. We used to build cardboard shades for laptops, in order to see the screen in sunlight. I always use an umbrella to sit in shade when I’m measuring with my 230Z. 73,

Yes, tried the contrast mode and same bad readability in direct sunlight even with shielding from the direct sunlight it is just hard to read for me. Normally I use rechargeable Panasonic? Eneloop