开云体育

Cheers Walker. My reader bar does have the zebra strip. MXF file attached. This is a measurement of the Piezography 129 step chart for i1Pro 2 taken in scan mode. -- instagram.com/itsmrjack_ (

One thought I just had too . . . a few people have got i1s that don’t have the little black and white chart on the reader bar. There is a position sensor on the bottom of the i1 that reads a zebra

Hey Chris, Please attach the measurement data and I can see what is going on. Please include spectral values as well as the normal lab values too. An MXF file format is fine (this has spectral

I am getting a sawtooth/jagged line from my measurements of a test chart, when taking the measurements in scan mode, but not in spot mode. Using an ES-2000 spectro, measuring Piezography test charts

Hi Jess, First let me say that I am not a commercial fine art printing studio only a single person artist. So my needs, and solutions, are very specific, and in some ways similar to your

The new P 900 is absolutely fantastic for printing film in general i have both an old mac air i use with older epsons and a newer mac i use with the P900 Erika Greenberg-Schneider Chevalier de

Thanks for the reply Eben.? I've seen printers either on this group or a FB group write that they just disconnect it from the internet to avoid any updates of all software to be certain nothing

I'm trying to figure out why you want to disable the internet on this, and which version of OS X you want to use. I probably am misunderstanding your needs or plan.? But if I were setting up a print

Hello hive mind. I’m trying to avoid the issues with printing digital negatives on an Epson 3880 and Mac OS updates on my MacBook Pro.I have to update the MacBook Pro OS (for other reasons) and am

Same thing happened to me and it was a corrupted quad file. I made another one and it worked fine.

I have a strange problem. I built a new .quad and when I went to print it nothing was printed.? The printer load the paper, started the job, but there was no ink (I immediately aborted so as no to

I'm curious about this also, and I'm sure not the only one! many thanks to those working towards a fix or workarounds of the print preset issue ? -- itsmrjack.com ( https://itsmrjack.com

Each day seems to be different when it comes to starting out printing on polymer plates. Yesterday went fairly well, but today has been incredibly difficult. 1. When the P900 asks for what type of

Thanks for the reminder. I actually did that with the P9570 this week, but it did not occur to me to do the same for the 700. It’s that time in the semester, when logic and reason are replaced with

The actual epson drivers for the older MacOS system will install and work perfectly. Tell your IT department to stop being dink-a-donks -Walker

Translator That did the trick ! Thanks a lot ;)

Hi Y'all - The IT Dept at my Univ forced and update to Sequoia. I put it off for as long as I could. It seems Epson does not now have the stand alone driver, it is only their Epson Connect Printer

Thanks for the idea, It's not how I understood this value. I think I tried with a value of 1s. I will give a try with an higher time

could it be that your increased drying time needs to be longer? When the increased drying time is less than what it takes to make one pass, you will not see any difference, as far as I know

Hello, I have a problem that is not directly QTR related but there is probably someone who would have an idea about it here. I need to increase the drying time between each pass for a specific