I’ve just changed the hotspot that my Qnet gateway is running on from a Zumspot to a full duplex MMDVM board put out by n5vboc. Yesterday everything worked fine, but last night before I went to bed, I moved the hotspot from down here in the shack to upstairs in my bedroom, and connected. ?Now I do have a mesh system, so there is definite wifi access up there, and I doon’t think that there should be an internet connection issue. ?However, when I came down this morning to key up on d-star, I’m getting a sound that sounds like Darf Vader when I unkey. ?Here are a copy of the MMDVM logs if anybody can make sense of this:

***COde end***

I ahve changed a couple of things. ?First, I now have full duplex enabled, both D-star, and YSf gateways are using 434.000. ?I’m not opposed to changing them to different freqnencies if I need to, I was under the impression that Qnetgateway would act upon whatever mode got sent to it. ?I don’t have the YSF gateway starting being connected to any reflector, it just loads, and sits there. ?I did try turning on my Ft-70, and tuning to 434.000, and enabling the wires-x button, trying to determine if that would work at all, but I have assumed that since I don’t have wires-x pass through enabled, that would work… SO any help y’all can give I’d appreciate.

Thankjs,

Justin

I got that issue resolved. ?I did recompile the gateway, and made sure that the tx, and rx frequencies were 5 MHZ apart, and that seemed to fix the issue. ?You really helped me with that and I appreciate that.