开云体育

It's the diode connected to the black connector at the top middle of the picture.? ?Do you see it now

good advice. Any chance you could resend one of those pictures with the component circled? that'll make it a little easier when I get home and dig through my 10,000 emails. If not, it's easy enough to

Connie and Hiroki,? it's a simple fix.? Just be sure to pay attention to diode band orientation.

Lower left corner.

I blew the BS170 final transistors (set of 3) twice due to inadvertent high SWR and had to replace them. Fortunately, the replacements transistors are inexpensive. Doug, when you say place 1n47576

Thanks for the tip– – I will look into this once I get back home. I'm glad I have a radio I feel comfortable just opening and modifying. 73, Connie W6EFI

Connie,? I? strongly encourage you to install a 1N4756A diode between rf and ground.? It will? protect your finals. Doug

*keenly lol

I am on the road right now, currently in a hotel in Tehachapi. Last night I set up my truSDX connected to a small MFJ16010 tuner, then tossed a wire out into a tree from my balcony, and dropped

I am following your adventures here, Kinley. Please keep us updated. I will probably copycat down the line.

We went to the city before I really got serious about ordering it. The city said "as long as it is for ham radio and is less than 35' high you don't need a permit". I have a printout from the city and

It was really your input, Doug, that won the day at city hall. All I had to do was show them that Doug Hendricks had verified that the antenna height did not exceed city ordinance. Thanks for your

Contrary to my earlier note, I will not make it to the Baylands at all today. The delivery time of our new bed has been rescheduled for this afternoon. Have fun everyone. Hiroki

Joy, if I were you, I would get the installation plans approved by the city of Sunnyvale.? ?Ask them for all rules and regulations concham radio antennas.? ?When you finish ask them to verify that

Great suggestion... got pix with DVM showing short over 30-40% of tuning range, will send in a day or so.

*MEMBER BULLETIN* June 6, 2024 Dear ARRL member, We are writing to inform you of a serious incident that has impacted ARRL’s operations. On or around May 12, 2024, ARRL was the victim of a

I used Mastrant-M 5mm-3/16”. Very pricey but very comforting to know its there when the wind is gusting over 50mph. I have some left over that I would sell at a very reasonable price.

Is this the guy line I would get for my new hex beam? Dacron Rope, no stretch UV proof. It comes in 1/8",3/16", 6"16" and 1/2" from KF7P.com? Joy N6GO (PS, I told you there would be questions)