开云体育

Using my QMX+ I had W1AW on 14.047.5 firmware 23?

I installed .25 W1AW was then at 14.047.6.?
I checked the RIT it was 0.000.?
I reinstall .23 and W1AW was on 14.047.5.?
I checked the freq against other rig they were all on 14.047.5.?

I did not load .25 on my other two QMX’s

Any thoughts.?
Larry

?

Larry, how are you determining the actual receive frequency of this CW signal? If you’re tuning it for the same tone frequency on your other receivers, then just check the CW offset setting in the QMX+. As an example it might be set to 600 Hz with the new firmware. If you tune it till it sounds like 700 Hz from another radio the dial frequency will be off by 100 Hz. There are lots of filter options and settings capable in this new release. The operating instructions for _024 have all the details. The manual for _025 hasn’t been released but operates the same.?

Ron

I never thought of the new VFO changes from 24.?

I’ll check it in the?morning.?

I was also listening to W1AW on 14.0475 last night using FW 1.00.025.

It was right on frequency for me (I didn't measure to see if the audio tone was at 700Hz, though).

?

73, Mike KK7ER

?

Ron you are correct. The update had set to 250/500, I adjusted to 300/700 all is back to normal now.?

I must say l updated a QMX+, QMX high band and QMX low band and each one was different. I adjusted all back to same using PuTTy all are running fine again.?

Thank you for you input.?
73?

Larry NA0F