开云体育

I have just built my QMX, however it is deaf probably because it is using 20, 17, 15, 12, 11 and 10m but I built it for 80, 60, 40, 30 and 20m.
Does anyone have a clue what is going on please?

Upon installing the firmware, at first boot, the software asks what flavor of QMX it's running on. You probably answered "20-10m" by mistake.

Make a long press on the left small button, the menu appears. Turn the right encoder to access "System config" then short press the left small button again, you should see "20-10m" selected. Short press the left small button, then turn the right encoder to select "80-20m". Short press the left small button to accept the change, then short press the right small button two times to exit the menu. Power cycle the QMX and you should be ok.

Alternatively, you can do a full factory reset (access the menu as shown above and scroll to "Factory reset") and select "80-20m" after the automatic reboot.

Regards,

YO3GFH
op. Adrian

Thanks very much Adrian! Now have a fully working QMX!

Great news!
Have fun with it!

Regards,
YO3GFH
op. Adrian