OCX+ T1 Toroid Continuity Process

Bill Jobes All Messages By This Member #118119 Greetings and thank you for indulging a rookie question. I'm new to complex kits. I have wound, then soldered T1 onto the board, and have continuity in each of these points:? 1 to 2, 3 to 4, 5 to 6 and 7 to 8. Does this mean I successfully installed T1 and can proceed with construction?? I just want to know the precise continuity steps. - Bill W3WJ
Ronald Taylor All Messages By This Member #118195 Bill, you should also check for continuity from point 5 to point 8n to make sure they are connected perly via the circuit board at points 6 and 7. Should be OK to proceed. good luck ... Ron toggle quoted message Show quoted text On Thu, Feb 15, 2024 at 8:19?PM Bill Jobes via <jobes=mail.com@groups.io> wrote: Greetings and thank you for indulging a rookie question. I'm new to complex kits. I have wound, then soldered T1 onto the board, and have continuity in each of these points:? 1 to 2, 3 to 4, 5 to 6 and 7 to 8. Does this mean I successfully installed T1 and can proceed with construction?? I just want to know the precise continuity steps. - Bill W3WJ

开云体育