开云体育

Hi All,

?

I completed my QMX+ and went to load the latest firmware (1.00_27).? The loading process went normal and I did get the initial setting to setup the bands.? I picked 160M-6m.? But what I found is that this did not initialize the QMX+ correctly.? I also noticed that the hardware tests looked strange (lpf, sweep).? I verified that the band options were set correctly, and still only got 80-20M,? I then did a factory reset, got prompted for the band selection again, and again picked 160m-6m.? But this still failed to have the correct band setup.??

?

I then loaded firmware 1.00_26 and when through the process again, but this time the band settings were correct, the band configuration menu was correct, and the hardware tests look good.? I haven't tried to reload 1.00_27.? I suspect something is not being initialized with the QMX+? from a factory reset/new install.??

?

Cheers,

?

Chris, w0anm

?

Hi Chris,

?What computer and operating system are you using?

? Have you exchanged USB cables?

? It may take another try with 1.00_27. I have had to delete old files and re -download once.??

? Thanks,

George

K3GK

?

P.S. if all else fails ......Hans :)

I am just following up here and responding to my message.? The issue I had was self inflicted .? When bringing up the QMX for the first time, I had the voltage set about 6.5V.? Now this should be OK for operation, however, it did affect the firmware load. This is the only thing I can think of that caused this issue.? I have reloaded 1.00_27 and had no issues.? All of the test screens look OK and no strangeness.?

?

I think it was just a fluke.??

?

73,? Chris w0anm

?

?