Hans,
I just got 4 AGC boards for my 4 QCXs. The original QCX rev 2 and 3 installations were easy and the directions excellent.
However, for my QCX-mini rev 1 and 2, I noticed a problem with the directions. On installing the first one into my rev 2 mini, it would not work. I checked my work against the diagram on page 9 and all looked well. However, when I eventually checked the picture at the bottom of page 11, I realized that picture and the diagram on page 9 did not match up. Tracing connections showed that the picture (not the diagram) was correct. I moved the AGC wire from the outer pin next to the paddle jack to the outer pin next to the mounting hole. All worked perfectly then.?
On proceeding with my rev 1 QCX-mini I noticed the same error on the diagram on page 13, but the correct wiring on page 15. So the second mini installation went without a hitch.?
I did not check the QCX+ as I do not own one of those.
It would be good if you could correct those diagrams, altho I suspect not too many QCX-mini rev 1 or 2 are being upgraded anymore.
--
73, Dan? NM3A
