开云体育

Erik The detector will receive on all odd multiples of the LO. However, as it is a sampling detector it means samples are missed. Even at 3 times the LO sensitivity is down by almost 9dB. 73 Alan

Thank you.? I'm working on your suggestions.? I appreciate the help, and I'm going to look closely at all of them.

When experimenting with BPF I noticed the receiver module will receive a station transmitting at 15.4MHz when tuned to an LO of 1.03MHz. Of course only when using a well tuned BPF to get rid of the

Tony, you may want to just cut off the old caps and solder new ones onto the pads to minimize potential damage to the pads -Steve K1RF Sent: Tuesday, June 26, 2018 9:23 AM To: [email protected]

Tony, N0PBA, no, you need to lower the value of C21 and C22 so paralleling additional caps with the originals will not get you there.? I also suspect that DC leakage that are a characteristic of

If you perform a RESET and follow Hans directions in DIAGNOSTIC mode there is a procedure to follow to fault find this. 73 Ken G4APB

In answer to your original question, manual entry of the maidenhead locator is for when you DON'T have a GPS connected. Once you add the GPS and select it in the menu it will automatically

Hi Jim Just to be clear: the extended byte is NOT inverted! In fact, the actual situation is that the unused upper 5 bits of it are defaulted to 1 in your programmer (and mine). This is an unfortunate

Thank you Robert. I just bought 100 ceramic 0.1 mfd caps Digikey so I’d have extras, so that’s perfect. I think I left my stock at home and I’m on the road again, but I will replace them as soon

Bill KF7YXS LCD showing only a top row of squares is usually a failure to initialize the unit. Showing the squares indicates that DC power is getting to the LCD. If one of the data leads was open the

GPS still works. Unit still pulling same idle amps.

My display went dark? it has the much talked about single row of squares. The U3S was working for days. I've searched the topics. Can't find where to start.

Just got the case kit in the mail today.? It looks great!? My question: What connector will fit in the GPS cutout?? It's too small for a 9 pin DIN.? I'd like to be able to use the QLG1 when the

On Sunday 6 meters was in and out with few contacts but one of our guys made 6 contacts with the ISS and 4 more later mobile on the way home. Our club, the Cherryland ARC in Traverse City, MI., had a

I have just completed my QCX 40, and have been able to make a few contacts with it.? I had to turn down the volume on the side tone, and when I did I encountered this loud clicking problem.? I too

Decided to buy a Rasberry Pi and try to reflash the RF module. While I have some experience with the Arduino I have none with the Raspberry Pi. Followed Hans’ excellent directions and worked

To Charles, NK8O, the .1 uF caps are non-polarized, ceramic or otherwise, so not electrolytics. 73, Robert, WA2T

All versions, for ever.... Ultimate, Ultimate2, Ultimate3, Ultimate3S... 73 Hans G0UPL http://qrp-labs.com

I have 3.12a...works for me. Roger --- ** Roger Hill ** Links: ------ [1] /g/QRPLabs/message/24833 [2] /mt/22676622/522301 [3]

In what version (firmware) this feature works ?