开云体育

If there are just two large pieces, you can superglue them back together and it should work fine. If there are multiple chunks, things get a little dicey. Jack, W8TEE

I wanted a tool, but not something that would take up room on my small workbench. ?So I purchased a KNIPEX Tools - Coated-Wire Stripping Tweezers (1511120) from Amazon, which is more expensive than a

Had all 24 turns of L512 wound and was trying to verify the turns count. ?Had it on a 3-D printed fixture and pressed down too firmly…

I'm in the midst of assembling my 2nd QMX+ and I just busted one of the Shiny Black T37-10 Toroid Cores...? DAGNABBIT!!!! So, where's the best place to by only one or two Toroid cores in the US? 73,

Correction:? You also need to know the phase difference between the voltage and current.? That's why you need two oscilloscope channels. <? then you have all the information you need to compute the

I wantched a youtube on the "$20 Amazon solder pot" and it looks like he had to fill the solder pot with almost a complete 1 lb(?) bar of solder, which seems to be about $30. So, I went looking a bit

Petrov, If you find the magnitude of the voltage? and the current at the amp input port using a two channel oscilloscope and a series resistor to help measure the current, then you have all the

I have a 20-10m QMX which I ran beta SSB firmware on. 20m wouldn't calibrate, but I tried Ellis Simon's band edge and band centre values and then the rig calibrated fine. I've just upgraded the

Dean, there is a fault in the SWR tune function (until now). If you start the SWR tune function your last VFO frequency is shown but a per band default frequency is used. Please rotate the frequency

Power down by removing the power plug. Then see if it will power up normally.

Stan, thanks for your answer. Hans the creator hopefully sorts this firmware thing out one of these days (hint hint :)) Ari OH9VL

Thank you Roger!! I was surprised to see the results into a dummy load so I went back to the original configuration and back to the same problem. So just curious to see my wattage I inserted a

So i would suspect the antenna/tuner to have an intermittent connection of some sort, or to be inadequate in some way. Roger Roger, I just checked and the SWR protection never faulted into a dummy

Obtained and replaced Q516. Diagnostics now pass Tx Bias. Stable current, all green. More testing tomorrow. Thanks for this group, helped me to track down the issue.

Roger, I just checked and the SWR protection never faulted into a dummy load. Full 4.9 watts on all bands. Dean

Stan, If I understand you correct, QMX + RIT and N1MM won't be a happy marriage by design. The RIT switch off issue in RUN mode is kind of weird. Anyway, it is a great contest radio. Enjoying it at

Does this happen into a dummy load? 73 Roger 8P6RX This seems to be a complex problem because I do not understand what is happening. I will try to explain as best as I can. QMX mid bands built for 12

This seems to be a complex problem because I do not understand what is happening. I will try to explain as best as I can. QMX mid bands built for 12 volts and Z-11 Pro auto tuner. I start on 40 meters

Would having the SWR sweep on the QMX display satisfy your need? I asked Hans for this a while back but I'm not sure if he read my request (busy guy). It seems that SWR sweep is the only terminal mode

I may have the same issue with my QMX+. It enters Safe Mode as soon as the key is pressed on 80m and 60m. The 40m and 30m bands work fine, although 40m and 20m have nearly zero power output, which I