开云体育

Ok thanks for the reply. It was a talent cell battery with a regulated 12 volt output. I did have the battery meter turned on and it was 11.6 - 11.7 volts. I will wait to hear back from the qrplabs

Arne, check solder joints from T507 to the board. 73 Ludwig

Hi Roy, I try to keep paper free where ever I can. When I was building my QMX+, I read off of the pdf document off of my laptop. I can highlight sections and make notes on the pdf, no problem. Cheers.

Hi, I wanted to tune my magloop antenna with the "Tune SWR" tool in the QMX+ menus, and no matter what I do with the antenna, the SWR never goes above 1.04 or so. That cannot be correct, as I'm using

I like paper in my hands, especially to write notes on. I print out all my assembly manuals. It’s just me. Some folks can just use their iPad or tablet but that’s not me. I also lime to read the

Thank you Stan for the support. I don't have smd welding equipment. I'm waiting for a response from Hans.

I presume you mean firmware version 1_02_000 Larry, You cannot enable the internal mic; you must use an external mic.? A future firmware version may (or may not) enable the internal mic.? Currently

I don’t know if I missed it in the manual, but how do you get the tx on when the two tone mode is selected? Also, is there any indication that the ext mic ptt signal is seen? I wired one up but

Ok I checked off the things on the list. Got to Q516 and checked it in circuit. It was open which ever way I tested . Removed it and tested again. Same result. So I figured I had nothing to lose and

I have no idea, for that coil.? It is very thin wire.? I do know that I have replaced one of those coils on one of my QMX boards - it is a bit tricky since the contacts are on the bottom, so you

Hi Stan, the copper wire seems to me to come from above and then go to be soldered at the bottom. Breaking the wire is compatible with breaking the edge, in that upper area of the solenoid the

I have also seen this behavior, which is due to the firmware 'automatically' selecting compatible frequency/filter combinations. Make sure to check out the CW filter description in the Operation

Wow - I've never heard that one before.? Just make very sure it is not moving because of a loose wire connection; that could cause a failure later on.

You are correct, that 160m LPF sweep looks fine. So the problem is most likely in the input side of the bandpass filter for 160m.? These are the connections I referred to in my prior post. Since all

I have you on the list. Please note that there is not yet a timeframe for a possible group buy - we are continuing to test v2 ABS Stan KC7XE

All communications to Hans regarding specific orders/problems need to be done via the support system at qrp-labs.com, if I understand correctly. No, the QMX definitely should not have failed after a

Wow, that's bad luck. The measurement of the antenna/ground is as expected - it is a DC short, but RF passes fine. The measurements I would take first are some voltage and current measurements.? The

Thanks for having a look Stan and for the suggestions and recommendations. Yes, noted the preinstalled caps. I will certainly take a look at the suggested reading material and have another good look

Hi Steve, Interesting read, thanks. Hopefully I can find a resolution..... I think last time we spoke I was using the QMX..

The coil is fine as-is.? The chipped top does not affect functionality. If the diode is working, there is no need to change it.? But it is a common 1N4148, so easy to find and replace if needed.