开云体育

This one has the image attached!!! Sent: Monday, 17 September 2018 16:45 To: '[email protected]' Subject: RE: [QRPLabs] Hellschreiber on U3S #u3s John Just starting to see your Hellschreiber in ZL!

John Just starting to see your Hellschreiber in ZL! 0445z 73's Pete ZL2iK/ZL4Ei RF74ci Northland New Zealand Sent: Monday, 17 September 2018 08:00 To: [email protected] Subject: Re: [QRPLabs]

Hi Peter, It looks like the Arduino Shield manual needs some updating! If you haven’t already figured it out... Jumper W4 & (W5 unmarked on silkscreen) connect Si5351A CLK2 to Arduino pin 1. Jumper

Just finished building one of my kits, decided on 40M as first one. This is one of the original 500 kits, yea I know I am slow, down time this weekend due to hurricane so went at it full bore. I have

Hi All? first time posting, just built my 20m QCX? and at first please it seemed to be working ok, about 2.5 watts at 13v which is ok for me but my problem... i can not find a peek on the front end

Remind me – what is your super-duper antenna? Mark Lunday, WD4ELG Greensboro, NC FM06be wd4elg@... http://wd4elg.blogspot.com SKCC #16439 FISTS #17972 QRP ARCI #16497

Thanks Mark! Hitting Alaska too...

Good copy here in North Carolina also Mark Lunday, WD4ELG Greensboro, NC FM06be wd4elg@... http://wd4elg.blogspot.com SKCC #16439 FISTS #17972 QRP ARCI #16497 [cid:image001.png@...]

Hellschreiber coming in nicely 2256 miles all the way from SW Washington state to Florida using 500 mW. ?I'm transmitting “AA7US CN76XH AA7US CN76XH” on a 10 minute frame.

Good evening, I am trying to set up my U3S with the receive module and have 2 questions I could use guidance with. 1.? I have set up Park Freq and Mode params as per manual.? Do I also need to set

Glad you got there. Have fun ! 73 de Andy

Thank you Andy! Using slow Hellschreiber mode with the speed you recommended did the trick. ?It looks great. Yes... despite the reduced signal strength, a little beaconing variety is what I'm looking

Don't use lead free Euro-solder. That generally solves most soldering issues!

Following on, I have a hiss from headphones attached to output jack fed through the polyphase network board. I am able to alter the volume of this hiss. If I touch input pins of IC3, 4 and pin 5 of

Glad you got it going without too much trouble. -- 73, Bernie, VE3FWF

Two things, Check the socket pins for good soldering and insure all the flux has not gotten into the socket. (rise well with Isopropyl alcohol.) Allison

Pulled out the micro-controller and reseated it. That did the trick. Thank you so much everyone for the help Much appreciated. Andy G0OEY

*Hi Hans, Hi all ! By playing around with the GPS Clock Kit, i wondered, if nobody else than me has the wish to to be able to display the latitude and longitude in different formats. The clock

Try pulling?out the micro-controller and reseat.? If no joy, recheck all the solder joints and touch up as required. -- 73, Bernie, VE3FWF

Yes I have. Before it would start ok with a couple of on/off cycles.