开云体育

85S running again

[email protected] All Messages By This Member #42416 开云体育 ?Finally got mine back together and running, but I still have a issue. Took it for a drive and have a vibration when accelerating, the reason I took it apart in the first place.? ?I replaced plugs, plug wires, caps, rotors but something else is wrong. Backed it back into the garage and was going to check the new plugs to see if they are all firing, but the hood release handle popped off, the cable is not budging, so I can’t get the hood open.? ?I’ll dive in at some point this weekend to try to get the hood open and plugs checked out, but what are your thoughts?? ?Clearly a cylinder isn’t firing, could it be injectors? Rob F. 253.209.8638 WPFC G12 Black WPFC G14 Navy GO PREMIER! One Club, One Mission! #alwayspremier
Scurry All Messages By This Member #42417 Mine did that and I found my passenger side CAM was one tooth off. Put porken alignment tool on and got it right on and did not have the vibration after that. David
[email protected] All Messages By This Member #42418 开云体育 Did it slip a tooth at some point, or was it installed that way? Mine was running fine for years before the vibration started. Rob F. 253.209.8638 WPFC G12 Black WPFC G14 Navy GO PREMIER! One Club, One Mission! #alwayspremier toggle quoted message Show quoted text On Jun 7, 2024, at 3:55 PM, Scurry via groups.io <drkekar@...> wrote: ?Mine did that and I found my passenger side CAM was one tooth off. Put porken alignment tool on and got it right on and did not have the vibration after that. David
Scurry All Messages By This Member #42419 I believe it was my fault. I had just had the lower end rebuilt and reinstalled it and that was when I noticed that it would vibrate when getting on the throttle. I had did what you did and replaced most of the ignition bits. Still vibrated. Rechecked the timing and that was when I found it. So a bit different than your sequence of events. David 1986.5
[email protected] All Messages By This Member #42427 开云体育 ?Been chatting with Tom about possible causes and I’m about ready to pull the fuel rails and injectors. I’ve confirmed that all the plugs are sparking, but I’m not convinced that I’m getting fuel to each cylinder.? ?I do have another question though. There is a 3 pin connector sitting directly behind the round diagnostic piece, and it has its own little bracket that holds it there. Can anyone tell me what that 3 pin connector is? Rob F. 253.209.8638 WPFC G12 Black WPFC G14 Navy GO PREMIER! One Club, One Mission! #alwayspremier toggle quoted message Show quoted text On Jun 7, 2024, at 4:08 PM, Scurry via groups.io <drkekar@...> wrote: ?I believe it was my fault. I had just had the lower end rebuilt and reinstalled it and that was when I noticed that it would vibrate when getting on the throttle. I had did what you did and replaced most of the ignition bits. Still vibrated. Rechecked the timing and that was when I found it. So a bit different than your sequence of events. David 1986.5
cjensan928s All Messages By This Member #42428 开云体育 Throttle position switch.? If it is broken Roger carries a replacement on his website that is a very nice piece.? Cheers Colin J 604-807-4523? toggle quoted message Show quoted text -------- Original message -------- From: "Huntnphool via groups.io" <Huntnphool@...> Date: 2024-06-10 6:49?p.m. (GMT-08:00) To: [email protected] Subject: Re: [PacNW928] 85S running again ?Been chatting with Tom about possible causes and I’m about ready to pull the fuel rails and injectors. I’ve confirmed that all the plugs are sparking, but I’m not convinced that I’m getting fuel to each cylinder.? ?I do have another question though. There is a 3 pin connector sitting directly behind the round diagnostic piece, and it has its own little bracket that holds it there. Can anyone tell me what that 3 pin connector is? Rob F. 253.209.8638 WPFC G12 Black WPFC G14 Navy GO PREMIER! One Club, One Mission! #alwayspremier On Jun 7, 2024, at 4:08 PM, Scurry via groups.io <drkekar@...> wrote: ?I believe it was my fault. I had just had the lower end rebuilt and reinstalled it and that was when I noticed that it would vibrate when getting on the throttle. I had did what you did and replaced most of the ignition bits. Still vibrated. Rechecked the timing and that was when I found it. So a bit different than your sequence of events. David 1986.5
cjensan928s All Messages By This Member #42429 开云体育 https://928srus.com/products/throttle-position-harness-tps-85-86-s3-32v-928-607-115-00?_pos=1&_psq=TPS&_ss=e&_v=1.0 Cheers Colin J 604-807-4523? toggle quoted message Show quoted text -------- Original message -------- From: "Huntnphool via groups.io" <Huntnphool@...> Date: 2024-06-10 6:49?p.m. (GMT-08:00) To: [email protected] Subject: Re: [PacNW928] 85S running again ?Been chatting with Tom about possible causes and I’m about ready to pull the fuel rails and injectors. I’ve confirmed that all the plugs are sparking, but I’m not convinced that I’m getting fuel to each cylinder.? ?I do have another question though. There is a 3 pin connector sitting directly behind the round diagnostic piece, and it has its own little bracket that holds it there. Can anyone tell me what that 3 pin connector is? Rob F. 253.209.8638 WPFC G12 Black WPFC G14 Navy GO PREMIER! One Club, One Mission! #alwayspremier On Jun 7, 2024, at 4:08 PM, Scurry via groups.io <drkekar@...> wrote: ?I believe it was my fault. I had just had the lower end rebuilt and reinstalled it and that was when I noticed that it would vibrate when getting on the throttle. I had did what you did and replaced most of the ignition bits. Still vibrated. Rechecked the timing and that was when I found it. So a bit different than your sequence of events. David 1986.5
[email protected] All Messages By This Member #42430 开云体育 That’s awesome, thanks. I moved it today and I crumbled in my fingers.? Rob F. 253.209.8638 WPFC G12 Black WPFC G14 Navy GO PREMIER! One Club, One Mission! #alwayspremier toggle quoted message Show quoted text On Jun 10, 2024, at 8:17 PM, cjensan928s <cjensan@...> wrote: ? https://928srus.com/products/throttle-position-harness-tps-85-86-s3-32v-928-607-115-00?_pos=1&_psq=TPS&_ss=e&_v=1.0 Cheers Colin J 604-807-4523? -------- Original message -------- From: "Huntnphool via groups.io" <Huntnphool@...> Date: 2024-06-10 6:49?p.m. (GMT-08:00) To: [email protected] Subject: Re: [PacNW928] 85S running again ?Been chatting with Tom about possible causes and I’m about ready to pull the fuel rails and injectors. I’ve confirmed that all the plugs are sparking, but I’m not convinced that I’m getting fuel to each cylinder.? ?I do have another question though. There is a 3 pin connector sitting directly behind the round diagnostic piece, and it has its own little bracket that holds it there. Can anyone tell me what that 3 pin connector is? Rob F. 253.209.8638 WPFC G12 Black WPFC G14 Navy GO PREMIER! One Club, One Mission! #alwayspremier On Jun 7, 2024, at 4:08 PM, Scurry via groups.io <drkekar@...> wrote: ?I believe it was my fault. I had just had the lower end rebuilt and reinstalled it and that was when I noticed that it would vibrate when getting on the throttle. I had did what you did and replaced most of the ignition bits. Still vibrated. Rechecked the timing and that was when I found it. So a bit different than your sequence of events. David 1986.5

Previous Topic Next Topic