开云体育

  1. N1MMLoggerPlus
  2. Topics

I wonder what I have set incorrectly

 

I haven't noticed this problem until this WPX weekend. I use a Flex 8600 and I noticed a disconnect between the radio and n1mm.

It seemed the program did not see the changing frequency as I moved the vfo knob. When I was in S&P the radio and program tracked using clicks in the bandmap. When I used my flex control knob, the freq would change on the radio but n1mm stayed on the last freq where someone was worked. If I switched bands the freq did not change to the new band.

All this isn't a problem if you exclusively CQ obviously but if you are jumping around getting the freq correct would be a pain.

Any ideas what I have set incorrectly?

thanks

Mike/AJ9C
 

If frequency does not track, the program is not seeing the radio.? That's nearly always COM port number of baud rate.? Device Manager is your friend.
?
73, Drew K3PA
 

开云体育

Thanks I'll check that again. N1MM has worked correctly in the past with these settings, most recently ARRL DX SSB

On 3/31/2025 12:03 PM, Drew Vonada-Smith K3PA wrote:

If frequency does not track, the program is not seeing the radio.? That's nearly always COM port number of baud rate.? Device Manager is your friend.
?
73, Drew K3PA

1 - 3 of 3