开云体育

Linkwitz to ground/source/drain

A Van Der Reijden All Messages By This Member #36848 Is there a way to connect a 3 pad electret (ground/source/drain) to the Linkwitz 2 wire solution? Thank you!
Craig Sawyers All Messages By This Member #36849 Does this give you the information you need? And? ? around half way down Craig toggle quoted message Show quoted text ------ Original Message ------ From "A Van Der Reijden via groups.io" <avdreijden@...> To MicBuilders@groups.io Date 18/09/2024 11:02:24 Subject [MicBuilders] Linkwitz to ground/source/drain Is there a way to connect a 3 pad electret (ground/source/drain) to the Linkwitz 2 wire solution? Thank you!
Jerry Lee Marcel All Messages By This Member #36850 开云体育 Although it's generally the contrary that is asked (modding a 2-wre into a 3-wire), it is quite easy to do. Just connect the source to ground. Another possibility is to connect a resistor between source and ground. That decreases sensitivity, but it also increases max SPL capability and decreases distortion. A typical value is 2.2kohm but actually the value depends very much on the FET and the desired change. Le 18/09/2024 à 12:02, A Van Der Reijden via groups.io a écrit?: toggle quoted message Show quoted text Is there a way to connect a 3 pad electret (ground/source/drain) to the Linkwitz 2 wire solution? Thank you!
A Van Der Reijden All Messages By This Member #36851 More info. than I can handle ;>) - very helpful, thank you.
A Van Der Reijden All Messages By This Member #36852 Exactly what I was looking for, thank you!

Previous Topic Next Topic