开云体育

Thankyou Ron

I found the manual you uploaded in the files section of the group. Thank you so much for scanning and uploading it Ron! Thank You Ron! l think I’ll finally get this little gem off the shelf and

I am looking for the same. has anyone had any good results? thanks Brian w7fdd

It is pretty amazing, from 20 pages to 60 for the same device! There is also an operator's manual on the same site, I think. ________________________________ Sent: Tuesday, February 25, 2025 8:16

Very interesting as I compare schematics.? R100 was cooked on my unit & measured 47R. But as I look at the various schematics, that is high or low depending... And the documentation is vastly

If you have this manual for sale, or know where to find one, please contact me. The HP Dymec 2411A Guarded Data Amplifier is an accessory for the HP 2401C nixie voltmeter. Kind regards, Terry

Thanx to all who responded. Looks like several companies have used this design & just rebranded it.? I do find a few small differences when I compare it to the Heath schematic. It is nicely

The Tek manuals are much

I think the Kenwood is a winner! Manual

Looks like kenwood fg272, Tektronix cfg250 Ed, k1ggi Sent: Saturday, February 22, 2025 9:10 PM To: [email protected] Subject: [ManualExchange] E&L FG-01 Sweep Signal Generator Hi

Thanx to Scott Petersen who correctly ID's this to a Heathkit SG1274! Nicely done, Scott.? Much appreciated. -? Bob

I don't see anything on that, but there are a couple of close matches, that may be the same machine with different cosmetics Heath 1274 Sweep Function Generator and the Tenma 72-5010 2 MHz Sweep

Claude it does not seem to respond normal but found this ... If you use ko4bb.com, you will get the old http://?access but if you use www.ko4bb.com or of course https://www.ko4bb.com, this will use

Hi All, Looking for any info on the E&L FG-01 Sweep Signal Generator.? Searched the web to no avail. Thanx - Bob

Sorry Claude I do not own a 3336 manual. I looked at Artekmanuals but it does not show there too. My 3325 papermanual (dated 1978) has no serviceupdates either so that's the information I had. Did you

Hi Rien. No problem, thanks for trying ! I tried Didier's site, but I cannot access the manual page. Is it working OK for you ? Claude /02/2025 12:23, Rien Eradus a écrit?:

Hello William. Yes I did, just to be sure I checked again.? Only one of their three links is for the 3336.? And it is for the 1930 series version with older version A6 CPU board. Thanks for trying

Have you tried Hp 3336B Manuals |

Hello Rien. Hello to all members. You are looking at an older version of the PCB.? My version has two dip switches, one for HP-IP address when used in a 3325 and a second one close to the front.?

Hi Claude From what I see on the 3325 board doc/diagram is that the dip-switch is considered for HPIB-address and/or signature testing. No indication for double use in a 3336. The ROM content will be