开云体育

Art,

I have tried several times to install this driver with RC10, I even went
back and completely reinstalled a fresh copy of Windows 2000 and I still get
the blue screen of death when I try to run the driver test or Mach2. I had
this working with RC7.1 but RC10 complained about using the wrong driver so
I thought I would remove and reinstall it. Well, that did not work for me
so I have now reloaded Windows 2000 and it still does not work. What have
I done wrong? I believe I have followed the instructions in the manual
exactly but I must be doing something wrong. Any help from you or anyone
else will be deeply appreciated.

John Guenther
'Ye Olde Pen Maker'
Sterling, Virginia

John:

Whenever you get a "wrong driver" message it means the driver is
too old or too new. In RC10, you MUST re-download the special driver
for non-apic boards again. It was updated at release time.
If you get this after downloading let me know.

Thanks,
Art

Art,

I have the latest driver, I downloaded it at the same time I got RC10. As I
said in another post, I even went so far as to re-install Windows 2000 and I
was still getting the BSOD when I tried to start Mach2 or the driver test
program. I will try again this evening. I had to deal with a very
upsetting family matter this morning so the last time I tried it failed but
I am sure it was my fault. I will make sure I pull every thing down again
when I get home and go from there.

Life would be so much easier if I had a motherboard that did not require the
special driver!

Thanks for the reply.

John Guenther
'Ye Olde Pen Maker'
Sterling, Virginia

John:

I may have screwed up the special driver update, I will check it.

Thanks,
Art
www.artofcnc.ca

--- In mach1mach2cnc@..., Art <fenerty@a...> wrote:

John:

I may have screwed up the special driver update, I will check it.

Thanks,
Art
www.artofcnc.ca

Hi Art
the updated driver worked fine on my system running win2k.

Derek