Mach 3 Mill, Exact stop

Graham All Messages By This Member #155596 I have re commissioned my 3 axis mill, All goes well, Except!!! The machine stops at each code block. Appears if smoothing, forward looking is not working. I have changed the CV Control settings, made no difference. Selected Constant Velocity/Exact Stop. Bought a new computer , thinking the older one was not up to the task. Made no difference. ? Can you offer any ideas??? ? Regards ? Graham ? ?
Wesley Wilcox All Messages By This Member #155597 Haven’t got single block mode turned on?
Martin Connelly All Messages By This Member #155598 Edited My thoughts as well. Alt-N or the button on the tool path screen will toggle it. When it is on the yellow LED above the button will flash.
sdmonaco All Messages By This Member #155599 Hi Graham, not sure what you mean by each code block.? One thing you might check is to see if the machine is slipping steps due to binding or excessive friction.? Sam
Graham All Messages By This Member #155600 Code block, I mean each individual instruction. No its not mechanical, I have a hand controller and motion is smooth and and calibration is very good.? ? I thought originally it was a PC issue, then replace the box, motion under code is just the same. ? Ideas??? Regards Graham
sdmonaco All Messages By This Member #155601 Stopping after each g-code line is what mach-3 does when it is in single step mode.? Check your setup and config file to make sure this is not the case.

开云体育