I have fiddled with arcs without offsets and now realize that i need to do the whole thing over but am working under somewhat reduced capacity and cannot learn a bunch of new programs.
I decided to try the two main holes starting over with cambam with the correct spacing. This will replace the mess I made before. I can deal with the few other holes later and use mach4 to determine the relative hole centers on the various 4th axis positions. I think there is a learning mode but it might take me longer to figure that out.
I think I have convinced myself that it is generally not good to use the quick and dirty easy method as it will bite you in the long run.
--
Best regards, Spencer Chase
67550 Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...
(425) 791-0309
