开云体育

Machine e stop activated mid cut

Richard Keane All Messages By This Member #154114 Hi, I am new to Mach 3 and I am having a problem with my cnc router. I make the G code on easel and load it on to my cnc computer on mach 3. The cut starts of okay but at random points the machine e stop is activated without me pressing it. I'm not sure if this is a cnc issue or mach 3. Any advice would be much appreciated.?
Paul Tegler All Messages By This Member #154115 No or NC switch EM stop config? noise (electrically induced signals) on your wires could be causing it ptegler toggle quoted message Show quoted text -----Original Message----- From: Richard Keane via Groups.Io <richardakeane124@...> To: MachCNC <[email protected]> Sent: Wed, Mar 11, 2020 6:39 am Subject: [MachCNC] Machine e stop activated mid cut Hi, I am new to Mach 3 and I am having a problem with my cnc router. I make the G code on easel and load it on to my cnc computer on mach 3. The cut starts of okay but at random points the machine e stop is activated without me pressing it. I'm not sure if this is a cnc issue or mach 3. Any advice would be much appreciated.?
Barry Albin All Messages By This Member #154116 开云体育 A couple of things to check. ?1) Version of Mach3. ?The version ending in “.062” is the most stable and may eliminate your problem. ?2) In config set the Debounce to 1000 and give it a try. ?If that eliminates the problem take the Debounce down to 500 and check it out. ?If all is well take it down to 200 and check. toggle quoted message Show quoted text On Mar 11, 2020, at 3:39 AM, Richard Keane via Groups.Io <richardakeane124@...> wrote: Hi, I am new to Mach 3 and I am having a problem with my cnc router. I make the G code on easel and load it on to my cnc computer on mach 3. The cut starts of okay but at random points the machine e stop is activated without me pressing it. I'm not sure if this is a cnc issue or mach 3. Any advice would be much appreciated.?
Dan Mauch All Messages By This Member #154120 Be careful not to set the debounce too high in the General Config menu because? if it is too high the table may hit the switch but delayed for a time greater than the actuation time of the switch and the speed of the router XYZ axis can handle. Dan Mauch
Richard Keane All Messages By This Member #154129 I tried to set the debounce 500 and 1000 and I still had the same problem. Not sure if this could be a machine issue. I will have a look at the wiring later on. Thanks?

Previous Topic Next Topic