开云体育

Mach3 single block problem

Dan Mauch All Messages By This Member #153850 Yesterday I was running a short G code file using the single block mode. For the first 5 or 6 single block moves everything went as commanded. But then even with the Single block led still blinking? it started to run the G code in the continuous mode. I have never had this problem before in many years of running mach3. Any ideas as to what cause this problem? Dan
Chuck Kahler All Messages By This Member #153851 Dan, I’m with you. Never seen this either. I’ve noticed some strange things lately though. I’m seeing these on Windows10 machine only, It’s connected internet. On windows 2000 and XP machine all is fine. Chuck toggle quoted message Show quoted text -sent from my iphone --
Peter Homann All Messages By This Member #153852 开云体育 Hi Dan, It could be an issue with the motion controller. Have you updated any thing to with that lately? Cheers? Peter Homann - (from my mobile) http://www.homanndesigns.com toggle quoted message Show quoted text On 20 Nov 2019, at 9:07 am, Dan Mauch <dmauch@...> wrote: ?Yesterday I was running a short G code file using the single block mode. For the first 5 or 6 single block moves everything went as commanded. But then even with the Single block led still blinking? it started to run the G code in the continuous mode. I have never had this problem before in many years of running mach3. Any ideas as to what cause this problem? Dan
Dan Mauch All Messages By This Member #153853 Nope the pc has a XP operating system. Strange. Dan
Dan Mauch All Messages By This Member #153854 ? It has the same setup for the last 5 years.? I think it was caused by a bug in Mach3. As y controls still runoff my parallel port.? Dan

Previous Topic Next Topic