Hi,
IIRC (and it's been years) this was usually caused by an issue with one of the installed plugin.
Try deleting (or moving) the contents of the plugins folder and see if you get the dialog back.
/Henrik.
------ Originalmeddelande ------
Skickat: 2022-03-03 21:59:25
?mne: [MachCNC] Mach3 Motor tuning ?
I am sure this has been beat to death but I am not finding a clear answer.
What is it Mach3, I can set Mach3 up and do the motor tuning (usually with minimal issues).
If in the future I want to go back and revisit the motor tuning the drop down refused to drop down. This is almost with out fail it refuses to open.
This is extremely frustrating. I usually end up reloading the version of Mach3 (62) and then installing the XML file and etc etc.
Is there any kind of solution to? this problem or am I the only one having this issue.
Ben
