¿ªÔÆÌåÓý

  1. Losmandy_users
  2. Topics

Duplex 6 wire for ST-8 & CG-11 Hand Controller

[email protected]
 

For whatever reason, I don't seem to be able to fabricate a duplex 6 pin
box for the hand controller and the ST-8 TIC cable to operate from. I am
using a 6 pin RJ25 duplex box and have it wire as the hand controller is
wired. The main plug is parallel wired to the second plug. The hand
controller works fine while plugged directly into the mount but when the
duplex box is connected, no power is seen at the hand controller. Any
idea as to where the proper wiring schematic can be found? This is
driving me nuts!! Any help is appreciated.

Steve
Peter Santangeli
 

If the ST8 is like the ST4 you could do what I do. I use a simple
6 wire telephone "Y" splitter. Bought it at Radio Shack. I think
Scott sells them too.

Pete

----- Original Message -----
From: <sreilly@...>
To: <celestronuser-response@...>; <sbiguser@...>;
<Losmandy_users@...>
Sent: Sunday, September 10, 2000 11:51 AM
Subject: [Losmandy_users] Duplex 6 wire for ST-8 & CG-11 Hand Controller



For whatever reason, I don't seem to be able to fabricate a duplex 6 pin
box for the hand controller and the ST-8 TIC cable to operate from. I am
using a 6 pin RJ25 duplex box and have it wire as the hand controller is
wired. The main plug is parallel wired to the second plug. The hand
controller works fine while plugged directly into the mount but when the
duplex box is connected, no power is seen at the hand controller. Any
idea as to where the proper wiring schematic can be found? This is
driving me nuts!! Any help is appreciated.

Steve



To unsubscribe from this group, send an email to:
Losmandy_users-unsubscribe@...

1 - 2 of 2