开云体育

This is a 6 month old G11T. I received an email from Tanya and in fact the worm adjustment is opposite from what is shown in a video they put out. Who knew? Any way lubing the bolts before tightening

I use Miele and it works well EXCEPT stellarium will close uncommanded when you minimize it but cartes du Ciel works. I'm still trying to find out why stellarium does this!!! Chuck

The meles go for around $200 with an n100 Intel chip. They come with windows 11. I dual boot to Linux and normally boot Linux for ekos/indi/PhD. -- jamie.amendolagine@...

The ASIAIR UI is tightly integrated and makes sense once you have some time with it.? But I don't like the handicapped autoguiding section which honestly would make it easier for experienced PHD2

If you have the inclination and time I'd go with a mini pc like a mele. You can then run the full indi / ekos stack that does not have competitor cameras disabled --? the asiair is using a branch of

Chip makes a valid point. ?With 3 systems in 1 package, you are 3x more likely to lose the item for repairs. ?Separate items allow swap out easier and cheaper. Plus, as he mentions, to upgrade. I

Make sure the worm gear is remaining parallel to the worm wheel and before fastening try a little synthetic grease under the bolt head and washer to help minimize the fastener friction as it is

Chip, What is the problem you see with the Duo design ? I am seriously considering a 2600MC Duo (not Air). Cheers, David Sent: 16 December 2024 01:14 To: [email protected] Subject: Re:

Confirm for us what mount you have, if possible include a photo so we can see what you are working with.? Also did you buy the mount new from Losmandy or is this an older used mount? -- Chip Louie

Hi Dan, I have been using the ASIAIR since the Pro version was released.? I have been using it on a G11G and GM8G with Gemini 2 minis and Tall boys communicating over Ethernet with both the ASIAIR

Thanks!? That is exactly what I needed!? I have some coming. Tom

I will call. They're pretty busy I'm sure. I've been using the mount all summer. Now that colder weather is here it needed adjustment. I was just hoping for a non-ordeal fix.

As I said before, call them during business hours to get in touch. Are you getting stalls even when the gear/worm mesh is loose? How balanced is your mount? Do you get stalls if you remove the motor

Well, even after emailing Tanya I get no reply. So here's what I have I'm trying to adjust the worm mesh to the gear on the RA axis. I'm getting an RA stall. I watched this video Titan / G11GT worm

I buy them from AliExpress by the hundred. Pretty much all made in Asia now. [image: image.png] [image: image.png]

Tom you caught me at a bad time to fully reply. ?But what you want is a 4P4C (4 pins 4 connectors) RJ22 vertical PCB mount socket this from digikey should do

Hi Everyone! I haven't been on here for a while, but I have decided to revive my old original Losmandy G11 with Gemini 1. Unfortunately I damaged the rj9 socket on my Gemini 1 rs232 port removing a

My astronomy club has a Losmandy Titan mount, recently upgraded to Gemini 2 L6.02.? We are looking at purchasing a camera for our scope, and we're looking at the ZWO ASI 2600MC Air, with the built-in

Thanks Paul. Jim [email protected]> wrote:

Hi Jim, in case you didn't get my PM: Thanks for sending the details. Feel free to post your items to the group. Regards, -Paul