开云体育

I will call. They're pretty busy I'm sure. I've been using the mount all summer. Now that colder weather is here it needed adjustment. I was just hoping for a non-ordeal fix.

As I said before, call them during business hours to get in touch. Are you getting stalls even when the gear/worm mesh is loose? How balanced is your mount? Do you get stalls if you remove the motor

Well, even after emailing Tanya I get no reply. So here's what I have I'm trying to adjust the worm mesh to the gear on the RA axis. I'm getting an RA stall. I watched this video Titan / G11GT worm

I buy them from AliExpress by the hundred. Pretty much all made in Asia now. [image: image.png] [image: image.png]

Tom you caught me at a bad time to fully reply. ?But what you want is a 4P4C (4 pins 4 connectors) RJ22 vertical PCB mount socket this from digikey should do

Hi Everyone! I haven't been on here for a while, but I have decided to revive my old original Losmandy G11 with Gemini 1. Unfortunately I damaged the rj9 socket on my Gemini 1 rs232 port removing a

My astronomy club has a Losmandy Titan mount, recently upgraded to Gemini 2 L6.02.? We are looking at purchasing a camera for our scope, and we're looking at the ZWO ASI 2600MC Air, with the built-in

Thanks Paul. Jim [email protected]> wrote:

Hi Jim, in case you didn't get my PM: Thanks for sending the details. Feel free to post your items to the group. Regards, -Paul

Yes,? the ST4 camera port connects directly to the mount. The camera USB to the ASIAir or wherever your guiding software resides. They all work basically the same way. Just to share my experience.

No problem listing gear for sale that is of interest to Losmandy users. If unsure, contact me (the owner) directly with details of what you have and I’ll let you know. Regards, -Paul

Hi Chip, On the iOptron SGP (non-goto as well), there is a similar ST4 port. My assumption was that I would hookup the ST4 to the guide camera (ZWO). Then connect the camera to the ASiAir using the

The ASIAIR cannot be used to directly autoguide the #492 digital drive.? The #492 can be used with an ST4 port autoguider but the ASIAIR cannot connect directly to a #492 for autoguiding as the #492

AFAIK offering for sale here is not explicitly forbidden but I think it is not encouraged.? The pool of buyers and sellers is much larger on CN and AMart so I expect you will have a lot more success

Folks- I don't want to veer out of my lane and misuse the group.? What is the procedure for posting info about some gear I have for sale? (apart from going to AstroMart, Cloudy Nights, etc.)?

Hi John Good to know about guiding performance with the old G11s...I didn't know that. Future proofing is a big part of why I am interested in the Losmandy...if I cannot get that or if I need to spend

Get a straight thru Y-splitter for the RJ12 (6P6C) with male on one end and dual female on the other: Or, if needed to clear the IN power jack, a single female to dual female and make up a little

Terran Industries is here in the Chicago area, and you buy stuff directly from them, not AliExpress. Mark C

Some caution is advised thinking the cheap OnStep kits on AliExpress will work with the old G11s. The motors are underpowered are not the same as the OnStep forum recommends. And AliExpress does not

Of course they do.? But you will get the most responsive and widest range of experience right where you are now. -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric Forecast - South