开云体育

Hi Ray, thank you for getting back to me. I have attached a zip of 5 files, 4 are the log file data runs for Nov. 13th, the 5th is the debug file for those runs. Run 1 - File 210114 (Full 30 min, Log

Hi, I'm looking for the dimensions(particularly the hole spacing) for the D Series Dovetail Plate for Meade 14" OTA. A cad .Step file would be best, but a pdf will work just as well.

Hi Mike, PEMPro reads the Gemini 2 settings using the Gemini ASCOM driver. It could be that communications failed intermittently between the Gemini driver and the mount, leaving some parameters

Thanks all. ?Good advice.

Hi, I posted an issue over in CN Software, but I don't seem to be getting someone who may know the answer. I decided to map out and see about improving the basic PE in my mount using PEMPro. I have

Thanks all. ?Good advice.

The simple answer here is to replace the saddle on the mount with the dual D /V saddle. You can move your C8 back and forth as it has a V style rail.? Any other scope will have one or the other. The

How long your mount holds PA really depends on how much you jar it with any one action. Just putting a scope on may or may not nudge it of place. I think for larger heavy scopes this would be more

My previous long time strategy had been to use 3x 1lb threaded weights that thread into each other like a stack of pancakes and then threaded to end of CW shaft in place of toe-saver bolt. ?I found

I can verify that the PA is unchanging over months of taking the scope on and off of my gm811g. In fact I store both the scope along with the mount inside, and am able to reposition everything very

This is fantastic. I'll be printing this tonight. Thank you!!! Regards, George

Hey George, Happy to share: here is the .3mf file from my Bambu P1S, but I also am attaching the STL exported from Fusion 360. I printed it out of PLA at 100% fill, but I'm sure you could go with a

How well your scope stays well polar aligned depends on the quality of your mounting hardware and how much you bang on the mount while loading the saddle. For visual this is not a big deal but for

Thank you both Paul and Ryan. Thinking this through, the easiest thing for me to do would be to just slide the counterweight down on the east of the meridian and slide it up on the west. To make the

Forgive me if this is posted somewhere, but I did a search and I couldn’t find exactly this. I am at a fork in the road on building my observatory. Either a very small outhouse type covering just my

Pretty sure the first use of the 1.75" wide bar by Vixen was for the C8-SP. The female saddle was mounted on the rear cell of the C8 using its two rear weight system mounting holes. The dovetail bar

Hi George, A little East-heavy balance is needed with most non-spring-loaded worm/gear mounts (including G11T). This is because the worm and the gear can't be meshed too tightly in such a system, as

Hey George, I'm not a G11T user but I do use East-Heavy with my G11G and I have noticed an improvement in general. I had an ADM balancing weight with a vixen clamp and I 3D printed a sleeve that

I just received an axis upgrade for the G11T. Travel, poor weather, and stuff still coming in for my imaging setup will prevent me from putting everything through its paces. For G11T (with Titan RA

On Mon, Nov 18, 2024 at 07:40 AM, WayBack wrote: > > On Mon, Nov 18, 2024 at 09:54 AM, George Cushing wrote: > >> Celestron bar > > > The discussion prompted me to examine the terminology, as I